Hey folks - so I've had some UI crashes (Merlin firmware - I won't say 'version doesn't matter', but I'm currently on 384.7_2). Any thoughts/experience/ideas?
Long story short, I have an AC5300 as my primary and two (2) AC68U's as extenders (repeaters).
Issue: Trying to enforce parental controls on the repeaters
Since clients pick up unique IP addresses (DHCP) from the repeaters, and adding the IP to the master doesn't do anything, I went into parental controls on the repeaters.
After saving, boom - can't get into the UI.
It still serves the network - I can connect via Wi-Fi to both of them - but cannot get into the UI unless I power cycle.
In earlier cases, I've had to go as far as factory reset (reinstalling firmware hasn't worked).
Long story short, I have an AC5300 as my primary and two (2) AC68U's as extenders (repeaters).
Issue: Trying to enforce parental controls on the repeaters
Since clients pick up unique IP addresses (DHCP) from the repeaters, and adding the IP to the master doesn't do anything, I went into parental controls on the repeaters.
After saving, boom - can't get into the UI.
It still serves the network - I can connect via Wi-Fi to both of them - but cannot get into the UI unless I power cycle.
In earlier cases, I've had to go as far as factory reset (reinstalling firmware hasn't worked).
