Unable to access - 192.168.100.1 address - AX86U Pro

[dineshgyl]

Hi,

I am using NOKIA ONT connected to AX86U Pro on WAN 1G port. ONT is connected to Fiber cable.

I think ONT is on port 192.168.100.1

AX86U is configured in router mode.

I followed this thread and added this -

Adding 192.168.2.x address to WAN port?

I'm trying to access the web interface of my Draytek Vigor 130 (in bridge mode) but my Asus RT-AC86U is not letting me. I asked on the Draytek forums and I've been told that I need to add a 192.168.2.x address to the WAN port of my router, if it will allow me. I'm running Asuswrt-Merlin. Is...

www.snbforums.com

ifconfig $(nvram get wan0_ifname):0 192.168.100.2 netmask 255.255.255.0

This is what it looks like after running the command

Any help?

 

[bennor]

I followed this thread and added this -

Followed what thread? No link provided.

What firmware is the router running?
Note that this subforum (ASUS AC Routers & Adapters (Wi-Fi 5)) generally discusses AC series routers, not AX series routers like the RT-AX86U Pro.

ASUS AX Routers & Adapters (Wi-Fi 6/6e)

Use this forum for posts related to the ASUS 802.11ax (Wi-Fi 6/6e) devices, such as the RT-AX88U

www.snbforums.com

 

[dineshgyl]

Updated the link. Firmware is Firmware:3004.388.8_4

 

[Justinh]

First, you "think" you know the ONT's IP address. Know for sure. Second, not sure why you need a route for it; I can get to my AT&T NOKIA GW w/o any special router config at http://192.168.1.254/.

What is your ASUS router's network address?

 

[Ripshod]

In the UK Nokia ONT's are basically just media converters with a MAC. No OS - no GUI.
There is a little bit of code accessible from the Internet, to give ISPs and carriers access to some control and diagnostics, but that's about it and it's innaccessible by the end user.

 

[dineshgyl]

As per this - https://hack-gpon.org/xgs/ont-nokia-xs-010x-q/

It should have a webui

 

[Ripshod]

As per this - https://hack-gpon.org/xgs/ont-nokia-xs-010x-q/

It should have a webui

But it doesn't, unless the ISP requests it be enabled. Stops users messing things up and needing intervention. There are a couple of hacked bootloader that will enable everything on these, but you need to use jtag for that.
Who's your isp? Don't say vodafone.
*edit* There's no mention of a gui in that article btw

 

[dineshgyl]

I am from Canada, its bell subsidiary - Distributel.

 

[Ripshod]

Good luck getting in then. You need the usb-serial interface (3.3v ttl) and a lot of learning before you attempt anything on this. Kill it, kill your connection.
It's not as simple as just logging in.

 

[bennor]

As per this - https://hack-gpon.org/xgs/ont-nokia-xs-010x-q/

It should have a webui

Simple test (if you haven't done so already) is connect a PC direct to the ONT and try to access the supposed webui whoever Hack-gpon.org is says is there. Would not be surprised if the ISP blocked local GUI access to the ONT by the customer/end user.

 

[Ripshod]

GUI access is blocked by default. Can only be opened up by either the ISP, or by enabling over the serial header (telnet/ssh).

 

[dineshgyl]

I connected my computer to LAN cable which is directly connected to ONT and set IP as 192.168.100.2 and gateway as 192.168.100.1, i was able to access 192.168.100.1 page then. So not sure what config needs to be done in router to allow this to happen.