Problem 1: Unstable internet
I had setup MoCA network for a few weeks, it works great most of the time, but it randomly drops internet connections probably once every hour for about a minute or so. I did a little bit of research, and someone suggests that changing the band to D high might help, so I tried to change my MM1000 from 1150, band D extended to 1500, band D high, but I couldn't get it working. My network diagram is attached below. Here is what I tried:
Problem 2: Can't get bonded 2.0 speed
I have Fios Gigabit internet at home. I didn't use the MoCA built in the Quantum Gateway because it is not bonded 2.0. I believe all the nodes (MM1000 x 2, WCB6200) in my diagram below are bonded 2.0. However, the maximum internet speed I can get is around 600Mbps. When I log into MM1000, I saw the Rx PHY rate is at 687Mbps.
Q: ~600Mbps feels like the standard 2.0 speed to me, I was wondering why I can't get bonded 2.0 speed.
Another question: is there a way I can get rid of the quantum gateway? It feels somewhat redundant(?) to me
Thanks in advance.
I had setup MoCA network for a few weeks, it works great most of the time, but it randomly drops internet connections probably once every hour for about a minute or so. I did a little bit of research, and someone suggests that changing the band to D high might help, so I tried to change my MM1000 from 1150, band D extended to 1500, band D high, but I couldn't get it working. My network diagram is attached below. Here is what I tried:
- When I change the MM1000 in the basement to 1500, D high, I couldn't get it linked with the WCB6200 (not sure about the MM1000 on the 3rd floor, it was disconnected at that point).
- When I change it back to 1150, D extended, it works.
- When I change the MM1000 3rd floor to 1500, D high, the WCB6200 and MM1000 on the 3rd floor can't establish the link simultaneously, i.e., when WC6200 is connected, MM1000 couldn't connect, and vice versa.
- When I change the MM1000 3rd floor back to 1150, D extended, all works well, except the internet will randomly drop.
Problem 2: Can't get bonded 2.0 speed
I have Fios Gigabit internet at home. I didn't use the MoCA built in the Quantum Gateway because it is not bonded 2.0. I believe all the nodes (MM1000 x 2, WCB6200) in my diagram below are bonded 2.0. However, the maximum internet speed I can get is around 600Mbps. When I log into MM1000, I saw the Rx PHY rate is at 687Mbps.
Q: ~600Mbps feels like the standard 2.0 speed to me, I was wondering why I can't get bonded 2.0 speed.
Another question: is there a way I can get rid of the quantum gateway? It feels somewhat redundant(?) to me
Thanks in advance.