webui broken on ax86u

  • ATTENTION! As of November 1, 2020, you are not able to reply to threads 6 months after the thread is opened if there are more than 500 posts in the thread.
    Threads will not be locked, so posts may still be edited by their authors.
    Just start a new thread on the topic to post if you get an error message when trying to reply to a thread.

zany130

Occasional Visitor
WebUI doesn't load some pages properly and just loads a white page since the latest update
 

Attachments

  • Screenshot 2021-04-06 224705.png
    Screenshot 2021-04-06 224705.png
    174.8 KB · Views: 48

kernol

Very Senior Member
Suggest ...
  • Clear browser cache;
  • Eject USB using eject button in webui;
  • Pull the power cord out of the back of the router [without pressing the power button;
  • Wait for two or tree minutes and then plug the power cord back in;
  • Wait for two or tree minutes BEFORE trying to log in to webui - then go for it and visit all the pages.
If that does not work - factory reset and manually add back all router settings may be the only cure.
 

AndreiV

Very Senior Member
You really should read the Changelog before updating firmware :

>> CHANGELOG <<

386.2 (2-Apr-2021)
- NOTE: due to changes in how custom device icons are handled,
first time you boot with 386.2 you need to either
shift-reload the main index page, or clear your

browser cache.
 

zany130

Occasional Visitor
so I think I know what might have caused it. I factory reseted my router( and formated my USB using amtm) and everything was working fine but once I setup all my settings and addons (did not restore from any backup I set everything up manually and by using amtm (scmerlin skynet unbound yazDHCP)) it started happing again. specifically, I think it started happening once I installed unbound
 

rlj2

Regular Contributor
so I think I know what might have caused it. I factory reseted my router( and formated my USB using amtm) and everything was working fine but once I setup all my settings and addons (did not restore from any backup I set everything up manually and by using amtm (scmerlin skynet unbound yazDHCP)) it started happing again. specifically, I think it started happening once I installed unbound
It is unbound (I had the same issue as you), think Ive given up on that app, its always causing issues, wrong install paths in scripts, have to reinstall gui on every reboot,etc.
 
Last edited:

Similar threads

Latest threads

Sign Up For SNBForums Daily Digest

Get an update of what's new every day delivered to your mailbox. Sign up here!
Top