Olli Haaslahti
New Around Here
Hi
I'm building a multi point VPN system with Wireguard, and hoping some here could help with the config.
The start point is: I have three location all with 172.16.X.X / 24 subnet lan and Raspberry 3 with Wireguard and Pi-Hole installed. All network have DDNS names.
Setup is this:
Network #1:
GW: 172.16.1.1
WireGuard: 172.16.1.3
Network #2:
GW:172.16.2.1
WireGuard: 172.16.2.3
Network #3:
GW: 172.16.3.1
WireGuard: 172.16.3
Networks 1 and 3 have NAS device connected and I would want them to be able to replicate information. Also network 2 device should able to access either of the NAS device. So basically I would need full lan connectivity between networks, so that normal outside/intranet traffic would go through the networks own gateway. What kind of WireGuard setting and routing would be needed to accomplish this? I tried to google guides on Wireguard point to point, but did not find anything helpful.
I'm building a multi point VPN system with Wireguard, and hoping some here could help with the config.
The start point is: I have three location all with 172.16.X.X / 24 subnet lan and Raspberry 3 with Wireguard and Pi-Hole installed. All network have DDNS names.
Setup is this:
Network #1:
GW: 172.16.1.1
WireGuard: 172.16.1.3
Network #2:
GW:172.16.2.1
WireGuard: 172.16.2.3
Network #3:
GW: 172.16.3.1
WireGuard: 172.16.3
Networks 1 and 3 have NAS device connected and I would want them to be able to replicate information. Also network 2 device should able to access either of the NAS device. So basically I would need full lan connectivity between networks, so that normal outside/intranet traffic would go through the networks own gateway. What kind of WireGuard setting and routing would be needed to accomplish this? I tried to google guides on Wireguard point to point, but did not find anything helpful.