Enabling WireGuard Client

[jkshowers]

Ok, so I am pulling my hair out.

No matter what I do, I cannot get the wireguard client to go from stopped to enabled.

The director shows it is enabled
I have clicked apply a million times.

the client tab shows that Yes enable is highlighted but says stopped next to it.

I would really appreciate some help! What am I doing wrong?

 

[Weblee2407]

Bad config file, probably because service uses OpenVPN format as far as I can tell. Import the config file using the OpenVPN button instead.

TorGuard OpenVPN 2.4 Client Setup for Asuswrt-Merlin Firmware - x3mtek Blog Site

This guide will show you how to configure the OpenVPN client on a Asus router utilizing Asuswrt-Merlin firmware version 384.4 with the TorGuard VPN service. You have two options to select from in determining how you want to route traffic thru the VPN tunnel. You can select All Traffic or…

x3mtek.com

 

[jkshowers]

Bad config file, probably because service uses OpenVPN format as far as I can tell. Import the config file using the OpenVPN button instead.

TorGuard OpenVPN 2.4 Client Setup for Asuswrt-Merlin Firmware - x3mtek Blog Site

This guide will show you how to configure the OpenVPN client on a Asus router utilizing Asuswrt-Merlin firmware version 384.4 with the TorGuard VPN service. You have two options to select from in determining how you want to route traffic thru the VPN tunnel. You can select All Traffic or…

x3mtek.com

On stock Asus Firmware The file works fine. I’ve tried multiple files to have the same problem.