Good Tutoral for strongSwan and IKEv2

[Ronv42]

I have been over to the strongSwan site looking at that as an option for VPN since it support IKEv2. There is a lot of information there but trying to decipher all their examples and configuration elements will take forever. Can anyone point me to information they may have found to help with this IPsec VPN? I have searched but most of the searches go back to the source web site.

I have a spare N66U in access point mode that will be used as a test platform behind my primary router using the Entware package. I first want to keep the configuration basic. Pre-Shared Keys and connecting only to the local network and back out to the internet eventually moving to a certificate mode for authentication.

Thanks.

 

[Ronv42]

I am getting close found this tutorial on the OpenWrt site:

http://wiki.openwrt.org/doc/howto/vpn.ipsec.roadwarrior

 

[Tietatter]

I am getting close found this tutorial on the OpenWrt site:

http://wiki.openwrt.org/doc/howto/vpn.ipsec.roadwarrior

Hello.
A couple of months trying to set up strongSwan on firmware tomato-K26USB-1.28.RT-N5x-MIPSR2-132-AIO-64K
As your link describes the installation for OpenWRT
On Shibby is not working.
Or am I doing something wrong.
Part of the error:
Collected errors:
* Opkg_install_cmd: Can not install package strongswan-default.

I have a device:
Model Asus RT-N66U
Chipset Broadcom BCM5300 chip rev 1 pkg 0
CPU Freq 600MHz
Flash Size 32MB
Total / Free Memory 249.73 MB / 212.70 MB (85.17%)
Total / Free Swap
Total / Free NVRAM 64.00 KB / 33.48 KB (52.31%)