Hello I would like first of all thank to merlin for his great firmware,
I have an rt ac87u with 2 different ISPs both giving me 200 mbps, I enabled load balance on 1:1 configuration and putted some computers on 1 wan and other on the second wan, all of the computers with the routing rules are beign routed to the desired wan, my problem is when for example I make a speedtest on wan1 all traffic from wan2 gets slow or it gets disconnected, I have checked both ISPS and it is not an ISP issue this happends only when intensive traffic is on the first WAN.
Is there any good config for this? I have tried several balance modes like 3:1 2:1 and ultimately 1:1 with the same results, all computers have a binded IP and all of them have routing rules per ip:
192.168.0.71 all
192.168.0.10 all
192.168.0.32 all
192.168.0.123 all
192.168.0.84 all
192.168.0.11 all
192.168.0.55 all
Regards
I have an rt ac87u with 2 different ISPs both giving me 200 mbps, I enabled load balance on 1:1 configuration and putted some computers on 1 wan and other on the second wan, all of the computers with the routing rules are beign routed to the desired wan, my problem is when for example I make a speedtest on wan1 all traffic from wan2 gets slow or it gets disconnected, I have checked both ISPS and it is not an ISP issue this happends only when intensive traffic is on the first WAN.
Is there any good config for this? I have tried several balance modes like 3:1 2:1 and ultimately 1:1 with the same results, all computers have a binded IP and all of them have routing rules per ip:
192.168.0.71 all
192.168.0.10 all
192.168.0.32 all
192.168.0.123 all
192.168.0.84 all
192.168.0.11 all
192.168.0.55 all
Regards