Veldkornet
Senior Member
Hey guys,
So I have a ZyXel GS1900-8 switch with the 2.10(AAHH.0)Co firmware on.
I've set it to receive a reserved DHCP address from my router, and I also enabled HTTPS for the GUI.
Now everything was working fine since I've had it for a few months, but yesterday I tried to login to the GUI and it just timed out... Even after a reboot, no success.
On the router, I can see that it does have the correct Reserved DHCP address, also if I log into my SNMP monitor it picks up all the info from the switch, I can ping it... It's just the GUI that seems to be dead. I tried the default IP address that it ships with anyway for the hell of it, but that also didn't help. Only thing I haven't done is a factory reset, which if possible, I'd like to avoid.
Anyone else ever have this problem? Any advice on how to fix it?
So I have a ZyXel GS1900-8 switch with the 2.10(AAHH.0)Co firmware on.
I've set it to receive a reserved DHCP address from my router, and I also enabled HTTPS for the GUI.
Now everything was working fine since I've had it for a few months, but yesterday I tried to login to the GUI and it just timed out... Even after a reboot, no success.
On the router, I can see that it does have the correct Reserved DHCP address, also if I log into my SNMP monitor it picks up all the info from the switch, I can ping it... It's just the GUI that seems to be dead. I tried the default IP address that it ships with anyway for the hell of it, but that also didn't help. Only thing I haven't done is a factory reset, which if possible, I'd like to avoid.
Anyone else ever have this problem? Any advice on how to fix it?
