Recent content by arpydude

I was using 3vpns of 5 possible vpn-clients on merlin 1 year ago. Performed an in-place upgrade to discover it has been dropped to 2 vpn client configs. I thought it was a poor upgrade so rebuilt. after searching I have found it was lowered with the upgrade and new install (or something I did)...

Thanks for mentioning that. ports 1-4 get 28mbs with the usb-ethernet adapater and takes very long to get served an ip address yet works fine (greater than 500mbs) with an embedded adapter. Since ports 1-4 are less than 100mbs (and not over like 200mbs was) I decided to force negotiation link...

Getting only 200mb on lan ports performed physical reset. have 500mb internet access. wifi access yields 500mb but lan switch max's out at 200mb (single user connected during test) switched out lan cable and port connections with same result. clean install 388 to merlin RT-AX88U_3004_388.5_0...

I can never write anything or correct things correctly. I just noticed i left out the offer to help test it on my update of the post. SMH. Yes I am definitely willing to help out with any testing necessary.

I went back and changed my last post after re-reading it cause i found I was rather lacking in description and courtesy. Not the way I thought it came across when i first typed it. I just want to say thank you for your time and effort for creating your scripts and responding to my questions...

Could not get Killmon to function with Yazfi with multiple ovpn's concurrently running and DOT for main network. I use DOT as my adblocker and is my preferred DNS protocol. lemme know if you make changes and I will help with the testing. I can verify it works great if your only using 1 ovpn...

What I have noticed as the main problem is during a reboot when the guest-wireless comes up it serves the main router lan ip 192.168.1.x and then when tunnels comes up restarts wifi and serves up yazfi 192.168.101.x. I installed killmon with paranoid and reboot mode and it does block outbound...

Thanks for the response. So if I understand the readme correctly KILLMON drops routing out wan based on all/subnet-range/ip at startup. VPNMON-R2 pings a selected ip address that is only accessible through the vpn and if it fails it restarts all vpns. nice compliment to the whole solution...

I also have noticed this with the same settings above that kill switch does apply during startup possibly before tunnel is up. Can vpnmon be used to circumvent this behavior at startup? (proton user) Would a startup script with a time delay bringing down/up guest-wireless-interfaces work or...

I guess it's just a friendly reminder to not cache your vpn password. ;) thank you for clarifying.

it was reset when I bought it. it was new and never used. But definitely worth note'n. thank you

Sorry I'm a newbie here coming from an openwrt-ddwrt legacy world. my understanding is a soft reset is factory default from web ui. factory reset done with physical buttons is/or was a hard reset. I'm saying that I was experiencing a problem with nvram increasing to a point where it was in the...

see what happens when I post before coffee. my port-lexia kicks in.

default wg is 58210 unless you changed it on your pivpn

setup: RT-AC68U acquired used genuine with a 384 stock on it. upgraded to a stock RT_AC68U_300438649703 then upgraded to merlinwrt 368.7_2 My setup had 3 openvpns at once with yazfi. added "auth-nocache" to vpn client custom configurations in each vpnclient. nvram came down and stabilized. I...