Recent content by Asus79

My client is set up for ipv4 only. I am using wg-easy on my VPS and when selecting AllowedIPs = 0.0.0.0/0 wireguard freezes my vps client and will not connect. I am using 0.0.0.0/1 which I think may be my problem

I have IPV6 turn on only to connect the router to my VPS because I'm behind GNAT. I do not have IPV6 Nat turned on.

I have a WG server on my AX-86U running Merlin. My peers are a GL-inet travel router and my phone. I have access to LAN from remote, and some webpages but not all. Google, Reddit, and webmail sites are blocked. Bing, news and sports sites work. I am trying to run the WGS traffic through my...

That write up makes sense. It is mostly the SMB shares that are slow. Thank you for all the help!

After a long time mucking around with it I have it working. All the reading has blurred my definitions but I think what I have is multi-hop. -Home behind CGNAT so I'm running Asus router Wireguard server IPV6. LAN on home is running IPV4 only because I have some devices behind a commercial...

wg set wgs1 peer endpoint xx:yyy:zz:xyz:nnnnn I've done enough reading and I think I'm beginning to understand. I am confused on the the above step, Is this the public key of the VPS server or a the VPS server peer? I get an error "key is not the correct length or format : endpoint"

The server is a Window PC. Are you saying I need to accept 10.0.0.0/24 on the PC itself? I was thinking the router does the conversation from 10.0.0.0 to 192.168.3.x I'll get the the allowed ips later today.

Just to confirm, server is switched WAN and incoming connections 10.0.0.0/24? I'm still having the same issue. Even after rebooting everything

Home / Asus router IP is 192.168.3.1, server is the PC I want to reach located at home. 19.168.3.46. the vps tunnel server IP is 10.0.0.0. I'm trying to reach it now with my phone though cell service so it doesn't have an IP range. Should I have NAT enabled on the Asus wg client?

This is my Asus setup at home

I tried to follow your directions but I am new to Linux scripting and got lost. I have attached screenshots of my set up, hoping that this will help. I have been using WGDashboard to set most of the system up. I have used the console to adjust the tables. Traceroute to my router's ip address...

My home network is behind a CGNAT and I would like to access a couple of computers on the network remotely. I have used the Hub and Spoke guide. The router at home is an AX-86U running 3004.388.10.12. I have set up a VPS running a wireguard server. I have tried a couple of setups and I cannot...