Recent content by B-dog66

Synology management port is changed to 16001, I check my NAS settings on the office and there it was 12001 and from there it came to change it. Changed back to Synolgy's original port 5001 I found the issue, it was the Synology's router configuration, my mind it was stuck on the Synology...

Hi all, I have a Synology DS220+ and it's setup with DDNS, done all the port forwarding rules on the NAS also on my GT-AXE16000. The first 30-40 minutes is working just fine, I can reach the NAS from everywhere, after is simply not reachable just randomly. I checked if the ports are open, and...

I got today an answer from Samsung support and they say that at the moment is not implemented in my region the 6Ghz signal, the Wifi 6E. Short long asnwer "We are working on it and it will be released an update for it" what is disappointing because the 6GHz signal is adopted in EU also in...

I tried this with my S22 last year and it didn't work, also I give a try to my S24 and the same nothing happens. I did reset all the Wi-Fi settings no luck, basically I tried everything what I could find on the internet. Luckily, my 5Ghz 160 Mhz (Wifi6) works flawless just I can't get to work...

I have an S22 and S24 ultra, non of these see the 6GHz signal, I tried all the channel one by one. In the other hand my wife iPhone 15 Pro Max see and can connect to every channel I changed the 6GHz signal.

I had 3004.388.4, so far I have done the following: 1. Removed USB from GUI and unplugged after 2. Restart the router 3. When I tried to flash from my main PC, same issue 4. Took my wife MacBook, and it was smooth flashing from that point 5. Also, get the same message to manually reboot the...

Cache cleared, but is the same, after I click to upload the firmware is displaying "Please wait, Applying settings..." couple of seconds and back straight to the login page.

Hi all, I have a tricky issue with updating the firmware. I have a GT-AXE16000 and when I try to upload the new firmware, every time is't jumping back to router login screen. I did try different browser or pc is the same. Any ideas what it could be the issue?

Hello Kamoj, Thanks for guide, only modification I have done is I disabled the Aegis cron job and since then 7 days 23 hours is AdGuard is running without any issues.

Hi guys, I have some issue with AdguardHome after 24 hours I restarted my router some applications on android taking long to load or to load the pictures like in the twitter. If I restart the router I have no issue for another 24 hour, but after it's starting again. What I tried so far is...

@kamoj Thankfully for your guides, since version V5.4b20 I don’t have any issues with the addon or the router! Apologises for the very late response, but I have been busy with my little girl and I don’t have the time to sit down and to reply. All my issues been resolved by disabling the “Save...

See below:

See below Kamoj post

Hey Voxel, If you are using the r7800 in AP mode, what router are you using? Of course if you don't mind sharing with us. I'm asking because I'm still a newbie in the routing network stuff. Regards,

Kamoj thanks for you patience, I will follow your guide and will report back to you. I don't use openvpn/wireguard because it's a bit slow, so I cannot say anything about it. DNSCrypt 2 I didn't used since you added Aguard Home, but I didn't have any problem with it till then, I need to think...