What's new
By:

  • SNBForums Code of Conduct

    SNBForums is a community for everyone, no matter what their level of experience.

    Please be tolerant and patient of others, especially newcomers. We are all here to share and learn!

    The rules are simple: Be patient, be nice, be helpful or be gone!

Recent content by carvwa

  1. C

    Curiosity question, WiFi Data rates...

    On a consumer device there may not be a compelling reason. However it would give greater granular control. I guess a similar feature would be the cut clients at -70 etc. One of the primary reasons is control frames are always transmitted at the "mandatory" rate, which is 1 & 2 Mbps for...
  2. C

    Curiosity question, WiFi Data rates...

    Just curious, it is best practice on enterprise systems to remove lower data rates (such as 1&2 mbps, even 5.5 for 2.4, and up to at least 12 mbps for 5 gHz). Is that possible on any (or Asus) consumer device? I've never really though about it before.
  3. C

    RT-AC5300 LAG and Cisco 2960g issue

    UPDATE: I've updated to 380.63_2. I forget what version I came from, it was at least a few back. I'll guess it was 380.61...but it might have been earlier. STATUS: LACP bonding WORKING... LACP port Admin Oper Port Port Port Flags State...
  4. C

    RT-AC5300 LAG and Cisco 2960g issue

    Hmm...that not ideal, but it would at least give me a solution. I'm running 3.0.0.4.380_3341, but I don't think this is Merlin version (yet). I see that ASUS has 3.0.0.4.380.3941 out. I'll try that (with both plugged in, and with just a single if the former doesn't work) and report back...
  5. C

    RT-AC5300 LAG and Cisco 2960g issue

    UPDATE2: As I suppected, Dynamic didn't fix the problem. It came back after reboot. But switching that appears to clear something....
  6. C

    RT-AC5300 LAG and Cisco 2960g issue

    I am using port 1 & 2. I know the other devices when you run lacp it's 3 & 4, but this one is fairly clear about ports 1 & 2. Curious though, what's the cli like on the SG's? I've only ever been on 1, and it was brief. UPDATE: I did make it work, though I'm not completely sure I understand...
  7. C

    RT-AC5300 LAG and Cisco 2960g issue

    Hey everyone, Is there a quick trick to making the LACP LAG actually work for the 5300? I get different results each time I try to make it happen. If I don't find a solution in the next day or so, it will be going back. I have a Cisco 2960g (ios v c2960-lanbasek9-mz.150-2.SE6.bin or...
See more
Back
Top
✖