Recent content by Cavey

Hi all, I just upgraded directly to the following firmware from 384, so far no issues *fingers crossed* but i am curious on a WAN portion setting, by default the NAT Type was on symmetric but i could not get internet access, it gave me an internal IP (presumably from the ISP) and then dropped...

Hello Grisu, Yup and that is what i did. Initially i had the impression that a 2rd AIMESH node works this way... since the routers may have seemed to be close by.. but when even the 8 port gigabit failed intermittently, i did RMA and the new unit seems to be working fine now. Thanks again.

Hello all, Recently i purchased 3x RT-AX88U and 2 of them are in AIMESH mode. setup and all seems a breeze and all seems to be working, except for 1 RT-AX88U in AIMESH, the 2.4ghz light does not light up at all. only the 5ghz is lighted. i know i can reset the following to test if it is a...

Hello all, So far so good after 5 days of running after doing the firmware upgrade. No reboots and all yet.. Just left AIProtection running as well which was off for me in the past. However in logs, not sure why i keep getting this though Jan 14 12:32:11 lldpd[378]: unable to get system name...

Decided to upgrade from 7783 to the current firmware, just used the GUI and installed the firmware from there. The new GUI Seems much slower compared to the 7783, Will try no reset first and see if any of the problems occur as above. So far after 12 hrs still ok .. will see what happens.

Do you mean the H/W version? i see a A2 below

Hey All, Just sharing, i did a warranty change of my RT-88U and upgraded to the then 3.0.0.4.380_7627 firmware, and for close to 3 months and all is ok (as in no drops from wireless devices), managed to last 40 days from the last reboot and currently its on 38 days and still ok..sometimes the...

Hey Lenin, When you say drop, does it mean either 2.4ghz / 5ghz disappear after some time and forces your device to connect to another SSID, or devices refuses to connect or generally they just keep dropping and reappearing again ? my previous RT-AC88U initially had the above issues where...

darn.. been on Merlin too long till stock is really so stripped down :) . Thanks Fax.

Hello all, I got my RT-AC88U exchanged and cannot remember, on the stock firmware version is there the following -> Administration -> Performance tuning as seen in http://i.imgur.com/o5O8cuf.jpg or is this only available on Merlin's firmware? Thank you.

Hello RMerlin, I moved from 380_64_2 to 380.66 beta3 yesteday on my AC88U, did the necessary factory resets to make sure no old settings were used from previous firmware version. Not sure why but when i tried to go in today to the gui it was very slow, i managed to copy part of the log before...

Hey Shandley, Going back to 380.64_2 seems better for me, but 2.4 ghz still goes out now and then after 4 - 5 days not sure whats the problem really. Rebooted it at the end of the 5th day as 2.4ghz didnt come up after waiting for a while.

I think it should be better. About 2 hrs so far so good. Also if u go wireless -> site survey ->Now that i am using back 380.64_2 i can see both 2.4 and 5 ghz, all the 380.65 firmware only shows 5ghz so perhaps its a good sign... Will try out for a week and revert :)

Hey Shandley, hows yours with _4? Just an update No luck for me .. , both 2.4ghz and 5 ghz disappeared after 4 plus days.. sighs will move back to 380.64_2 for now as suggested by muffintastic. C

Hello akb. my core is usually 2- 6 % load .. maybe i will do as others and get a usb fan or cooler tray Hello muffintastic, ok i noticed there is anew firmware RT-AC88U_380.65_4, will give that a go first.. if it fails i will go down to 380.64_2 Thank you both. C