Recent content by diehardfan

Tried both rebooting and power cycling, best I could get was 300KB/s. Unfortunately, gonna try Shibby and see if that works.

Currently, on Merlin build 3.0.0.4.270.24 on the N66U, can I just directly restore latest stock firmware (version 3.0.0.4.270) via the web UI Administrator -> Firmware Upgrade? Also, how do you backup JFFS on Merlin FW? Thanks.

most I am able to get is ~300KB/s. Any more advice? Any setting I should try? Thanks!

Ch 1 is the least populated channel in my area, there is only one other wifi on Ch 1 that can only be picked up in some areas of my house, but beyond that its there are 3-4 wifi in each respective channels. I am using 3 different devices next to each other for all my test, all android phones...

Currently on Merlin build 3.0.0.4.270.24 and having wifi speed issues. Using only 2.4GHz on Channel 1 (5GHz disabled) and the next closest wifi signal in my area is channel 3. I am on DSL 15Mbps/1Mbps profile. When I am standing right next to the router, I am getting close to full speedtest...

I will stick with NTFS then for reasons Merlin mentioned. Its a flash drive, fyi. Can you format the drive directly from N66U?

Is there a recommended file system for a USB drive that is attached to the N66U?

Understood. Notice you mention about disabling it in the other thread you created. It's not that important but would be nice. You should poke Asus about it :D Again, thank you for all you hard work and Happy Holidays!!!!

Thank you Merlin and keep up the GREAT work!!! Just curious, IF I plan on using dual WAN, both DSL both using ST516. Is it possible to access the 2nd modem connected to LAN 1 port? Am I asking for too much? :D

YAHHHH!!!!!!!! That worked!!! Awesome!!! Was checking the code inside those files, its a little different from the one your post, post #2 on this thread. These are the files I created, the two difference I see it the once you sent me had no enter and some additional command. Was that the...

was just browing via telnet and it seems like the files are executable Also, I just copy and pasted the codes directly from your instructions using notepad++ for the two files.

Yes I did make the scrips executable, but to be safe I did it again. Got a blank screen after I entered the "chmod a+rx /jffs/scripts/*" command. Then I put in still getting But its there when I telnet in..... :confused:

when I this type in Tools --> Cmd Run I get: Then I ran the scripts manually as you asked: Ran the wan-script code first: then got Got a little adventures and ran the nat-script too: :D and voila was able to access the modem's webgui at http://10.0.0.138/ So it...

when I type this command in Tools-->Run cmd I get this no mention of 10.0.0.2 NOTE: I put the XX:XX:XX in there, as that is the MAC address of my router. something went wrong?

The file copying went smoothly, just as you mentioned. But, what address do I use to access the modem's web interface now? Used to be http://10.0.0.138/ . 10.0.0.138 is still giving me cannot display the webpage I rebooted the router twice and these are the files I copied...