Recent content by egeym

  • ATTENTION! As of November 1, 2020, you are not able to reply to threads 6 months after the thread is opened if there are more than 500 posts in the thread.
    Threads will not be locked, so posts may still be edited by their authors.
    Just start a new thread on the topic to post if you get an error message when trying to reply to a thread.
  1. E

    Adaptive QoS does not show in GUI, AC68U 386.1 Beta 2

    I flashed the linked DSL firmware and it works like a charm. Thank you.
  2. E

    Adaptive QoS does not show in GUI, AC68U 386.1 Beta 2

    It's a DSL-AC68U whose DSL modem died so I just flashed Merlin to use it with a bridged ISP modem.
  3. E

    Adaptive QoS does not show in GUI, AC68U 386.1 Beta 2

    I tried enabling it through SSH with commands nvram set qos_enable=1 and nvram set qos_type=1, the menu bar at the top showed the gear icon saying it was "enabled" but the classification page showed blank graphs. I tried installing FlexQOS which did not help.
  4. E

    Adaptive QoS does not show in GUI, AC68U 386.1 Beta 2

    Unfortunately, the recommended steps did not work.
  5. E

    Adaptive QoS does not show in GUI, AC68U 386.1 Beta 2

    I downloaded it from Merlin's site.
  6. E

    Adaptive QoS does not show in GUI, AC68U 386.1 Beta 2

    I cannot enable Adaptive QoS, the only options are "QoS"and Bandwidth Limiter, as shown in the image below: I have done a factory reset after installing.
Top