Recent content by Fenix

Thank's I now about this but like Im understood this is able to do wnen router is up, but my router is going rebooting by cyrcle all time. That's why Im asking can flashing cfe over serial console command and what is commands?

Also later during booting Im able entering to busybox

Before even ifconfig doesnt show nothing but I found on forums msg to do nvram set et0macaddr=xx nvram set 0:macaddr=xx nvram set 1:macaddr=xx and now CFE> ifconfig Device eth0: hwaddr xx, ipaddr 192.168.1.1, mask 255.255.255.0 gateway not set, nameserver not set

I suspect something wrong with boot loader, guys can you give me internet sites more specific for repairing routers. Is it possible to re-flash CFE from situation with my router like now. I cant entering to CFE web GUI, all time going cycle rebooting and only way to repairer usb serial console...

Already tried nvram erase, what it mean switch is defective and how to resolve?

Tried already but all time tftp server error, could be initial router ip changed, that why asking any command from cfe console to check present router ip!

Second question is any cfe serial console command to show current router ip

Trying : CFE> ifconfig eth0 -addr=192.168.1.1 Could not activate network interface 'eth0': Error

cfe available commands: nvram, reboot, flash, batch, go, boot, load, save, ping, arp, ifconfig, show, help

cfe command: show devices received uart0 NS16550 UART at 0x18000300 uart1 NS16550 UART at 0x18000400 nflash0 AMD NAND flash size 131072KB nflash0.boot AMD NAND flash offset 0 size 512KB nflash0.nvram AMD NAND flash offset 80000 size...

Also trying ping from Putty usb serial cfe menu and received: 192.168.1.1 (192.168.1.1): 0 packets sent, 0 received

Trying from cfe command line nvram erase and after nvram commit but after reboot and entering to cfe mode put ifconfig command and received interface not configured

Eric for this moment only port 3 is working, I don't now why and I use this port.

Please assist me any Guru to recover my router. Finaly after one month I received USB-UART cable. After all preparations I'm able via Putty connect by serial port to router. If i press quickly ctrl-c able to enter cfe comman line or later if press enter to console command line. But how to...

Thnks's a lot Eric:p