Recent content by Fluss

  • ATTENTION! As of November 1, 2020, you are not able to reply to threads 6 months after the thread is opened if there are more than 500 posts in the thread.
    Threads will not be locked, so posts may still be edited by their authors.
    Just start a new thread on the topic to post if you get an error message when trying to reply to a thread.
  1. F

    Ethernet connection working from router but not from mesh LAN port

    Problem solved. :D Thanks everyone for your useful suggestions. @Wekiwa67 yup, a real pain and allot of wasted time. @Mark0 I didn't check to see if I was receiving gigabit via laptop upstairs, but that would have helped as it would also have suggested a partial connection. @Keith Gorham Yes...
  2. F

    Ethernet connection working from router but not from mesh LAN port

    So... I did another test by using a 20 meter lan cable in place of the LAN connection to the loft, from the primary node to one of the other nodes. This LAN cable is actually longer than the one in situ that goes to the loft. Once connected by ethernet, wired back haul was shown to be working...
  3. F

    Ethernet connection working from router but not from mesh LAN port

    Thanks for your reply. I only mention the configuration of T568A from wall socket to wall socket, to confirm that the LAN has been wired correctly and that it has been tested - to eliminate replies suggesting I should check the wiring. Besides, as mentioned I get a connection when connecting...
  4. F

    Ethernet connection working from router but not from mesh LAN port

    Hi all, I have been troubleshooting an issue, but I can't work out what's going on. Firstly, I'll explain setup. I have an ISP supplied router which I am augmenting with wi fi mesh units (Tenda nova MW6 - 3 pack) During to a recent loft conversion, I had the foresight to get the electrician to...
  5. F

    Tenda MW6 Nova setup help

    HI all. Hoping someone will be able to clarify/help. I will be taking delivery of a Tenda Nova MW6 (3pack) soon, but I wanted to get some advice before I start setting them up. Having read through this thread and others, it seems the best option is to put the units in bridge mode and let the...
Top