Recent content by frazor77

I'm going in via amtm, then it appears on the main tailmon screen, just not straight away (after ~20m or so)

Latest version (Tailmon 1.1.0 w/ Tailscale 1.84.0) = Yes Without issues now = No Its no longer in a restart loop, but its still erroring, possibly triggered by me logging in to AMTM/Tailmon: EDIT: The above showed when I finished reinstalling at 2058 last night then logged in to check at...

OK, that didn't work. It stopped emailing me failures every 5 seconds.... but still showed the memory error... So took off and nuked the whole site from orbit, only way to be sure. After a full uninstall and reinstall of Tailmon+Tailscale all seems OK. 🤷🏻‍♂️

Rolled back using : Then did a reboot. Will monitor.

Since updating it seems to be regularly restarting the service (and picks up speed) throwing the following: Eventually it gets stuck in a loop where the service goes down and it tries to bring it up again (KeepAlive is enabled) and I can't stop it manually and have to reboot the router

I'm using AdGuard Home managed AMTM -so that's in the middle, then it falls back to Cloudflare's Safe DNS ... but it solely seems to be my personal phone that's effected, so my current theory is that its my phone that's the issue (it gets regular updates and in fact had another this week so I'm...

OK the rollback of firmware did nothing, the problem persisted. I now think its possibly a fault with the phone or its software build - I had clearly forgotten that had gotten an update too. 🤦🏻‍♂️

Having some issues with mobile devices since updating to Merlin 3004.388.9_2 on my main RT-AX88U (with 2 ZenWifi DX5's attached, wired, both on ASUS 3.0.0.4.388_24022). The mobile devices (e.g. my personal OnePlus 10 Pro 5G) say they are connected fine, but then no apps can see the internet...

Hi all, I have an RT-AX88U with the previous RT-AC86U that I migrated from, now used as a repeater - My bricks and mortar house in the UK isn't big but I have a Ring Spot Cam in my garden that just can't get a good enough signal from the AX88U thats near the front/middle of the house, plus the...

So ~50-60h in my ring pro doorbell and my (Shelly) relay switch that controls my garage door both dropped off the network overnight (around 5.30am) and refused to reconnect (I tried rebooting and resetting both devices several times), last resort was router reboot that brought them back online...

I'm a mere 28h in... but so far so good.

So do you read 51D3 as SIDE? ;)

Been on a family break... here's the log from 50DA: https://pastebin.com/Ecg2xcAZ Will now try moving on to 51D3

Updated to 50DA... will report back. I don't have access to another compatible supply currently. If this update yields nothing, might try downgrading to see if 46e9 fixes it... either way that will show if 46e9 was the last good pre-break point or not.