Recent content by gp-se

On the 2.4Ghz band make sure to use channel 1,6, or 11. Set channel width to 20Mhz.

I would never turn that on, I keep most settings at default. Good to know my router is safe.

So having the latest firmware installed and performing a factory reset is all that is needed to avoid this issue?

I also use Bell, but I'm on 1.5 down, 940 up and using the Gigahub. I experience the same issue, using the Lan ports (gigabit) I get 940 down, 750 up. Wi-Fi even worse, 750 down, 500 up. Hardwired directly to the Gigahub gives me full speeds, so my connection is capable of delivering the speeds.

Hey everyone, I have a RT-AX86U using a PPPoE connection to my gateway. When I use the ASUS built in speed test I get the speeds included on my plan, which are 1.5gb/s download, 940mb/s upload. All my clients are connected via WiFi, using an iPhone 16 pro with Wifi 7, two laptops using Wifi 6 AX...

If I decide to use the Pi-Hole WiFi interface to connect to my guest network would devices be able to communicate with it? I have "access intranet" disabled because I don't want devices on the guest network interacting with each other, would I have to enable that setting for it to work? Also...

I am using the latest stock firmware. I rather not use WiFi even for the guest network because of latency. If I use "Use same subnet as main network" would that mean devices on my guest network can communicate with devices on the main network, defeating the purpose of guest network?

Hey everyone, I have an issue with DNS resolution that I'm looking for help with. I have a RT-AX88U Pro using Guest Network Pro and a raspberry pi4 running Pi-Hole. The devices on my LAN can connect to the Pi-Hole without issue, however devices on my guest network (VLAN) cannot. In the guest...

I've had mine for 5 years, it's been rock solid. I also don't understand why Asus leaves the AX86U for last, it was\is such a popular model.

I've seen RT-AX88U Pro with HW ver. 1.0 and 2023 production. The box and sticker on the router should say "RT-AX88U PRO" If it doesn't say Pro, or is manufactured before 2023 then it's the regular RT-AX88U, also the regular RT-AX88U has 8 Lan ports.

I use macOS and had the same issue when using Edge\Chrome. I realize you're using Windows, but perhaps there is a setting like on macOS to allow access. https://answers.microsoft.com/en-us/microsoftedge/forum/all/edge-on-a-mac-cant-access-local-ip-or-devices/15e7d07e-a552-4dad-8be4-63dbc97db7e2...

Either method would work, I prefer Restore+Initialize (tick mark) because it wipes everything.

Yesterday I purchased an AX86U Pro, I connected my Modem to the WAN port, then used WiFi to run the QIS. After setting the SSID and log in info I used the web GUI to update the firmware. After confirming the latest firmware was installed I did a Restore+Initialize in the GUI. I then set...

Updated, and did a hard reset just to be safe.

For 2.4 use Channel 1, 6, or 11. Preamble type: short, disable TX bursting. Disable Universal Beamforming.