Recent content by happyman

There is three modes. As far as I can understand, Repeater mode seems like my only option (see below, text taken from the admin interface). Wireless router: "In wireless router/ IP sharing mode, RT-N12E connects to the Internet via PPPoE, DHCP, PPTP, L2TP, or Static IP and shares the wireless...

I am inclinde to agree with you. But as I have purchased three of them. I would love to try all I can to get them to work before dumping them for three new ones. :) PS. At home I have a RT-AC68U router with Merlin. I was trying to find a bit cheaper router for these three locations as I don't...

You can see my setup, at page 7 (WLAN), in this installation manual http://www.tcmadmin.thermia.se/docroot/dokumentbank/Th_UG_VUBQD202_EN_X020105.pdf.

The heat pump is in a house (let's call it house B) with three tenants. As I still lack my own internet access I have been allowed to access the tenants WiFi. I have set my router to repeat mode and connected it to the tenants WiFi. The heat pump is connected to my router via standard network...

I did try to find a parameter in the nvram that would let me turn off the stand by mode, but was hard put to figure it out :). PS. I would be delighted if someone could point me to the correct nvram parameter in the attached file :)

@eibgrad: I'm as baffled as you are. :) But it's a "feature": ASUS writes: "Power saving: consumes less power during stand by mode (see https://www.asus.com/Networking-IoT-Servers/WiFi-Routers/ASUS-WiFi-Routers/RTN12E/). @Wallace_n_Gromit: I cron job might do the trick to prevent the router...

Background: I have purchased an ASUS RT-N12E C1 so I could connect my geothermal heat pump to the internet and access the heat pump via the resellers web interface (Thermia online). My issue: The router enters power save mode as only the heat pump is connected to the router, and the heat pump...