Recent content by HardCat

Ah! That makes more sense, I'll look deeper. Thanks...

OK, thanks but it only displays my wan uptime somewhere around 10 minutes or less because it keeps disconnecting and reconnecting, which as I stated is causing dnsmasq to be recycled also. Seems like an awful lot of disconnect, reconnects.

I am having an issue with scMerlin which I am not sure if this is something new or from an older version. Seeking clarification. In the messages logfile I am seeing numeroous wan-events for Stopped, Connected, and Disconnected. This behaviour is repeated approx every 10 minutes as shown in an...

@Viktor Jaep Possible Suggestion for enhancement, in the (A)viation WX would you consider breaking the METAR down into human readable format in addition to what's already there? Also, is it possible to change the Airport ICAO code in Aviation WX? This would be really useful for anyone that...

That's it, up and running again! Thanks for your many years of support!!!

Still getting the failure, this time: Rule Integrity Violation - [ #19 ]

Getting IPTables Rules [Failed] on version 7.5.5 here. Rule Integrity Violation - [ #23 ]

I use Torguard here, don't see it in your list.

I too have not done a reset and have had the issue with 386.4and 386.3.2, however mine seems to have resolved after installing unbound. YMMV.

This is such a fantastic little utility, thank yo so much for this!

A quick rename and a fresh install solved the Segmentation Faults and Unbound installed successfully. Thank you!

Ok, I'll give that a go later today. Thanks for the help and I'll let you know how it works out.

I got the same error. Might it be a problem with Entware itself?

Apologies for jumping in... After trying the above commands a couple of times, I still get the following and Unbound install fails. Not sure where to go from here. Do you want to ENABLE unbound logging? (NO recommended) Reply 'y' or press ENTER to skip Segmentation fault Segmentation...

Just installed on RT-AX88u, all went well during the installation. Thanks...