Recent content by JAAS666

Yeah.. after years of dirty updates I guess it finally bit me.

Anyone knows if AImesh nodes will rejoin if I factory reset? I don't think so right? A couple of them are on hard to reach locations.

Yeah you are probably right. Just wanted to make it clear that I've never done a factory reset when going from Merlin to Merlin and I've never had anything breaking like this In fact, I went back to 386.4_0 and after the router booted everything started working again. I might try to do it with...

RT-AC5300 from 386.4_0 to 386.5_2 No chromecast devices could be found. Reverted to 386.4_0 and everything works as intended. No hard reset after firmware upgrade.(never done one when going from Merlin to Merlin and never had problems before). I did reboot the router though. Anyone else seen...

Ok thanks. haven't found a way to set them without restarting the fw? or what's the reason?

Yes.. now it looks like its working correctly. About the AutoBW... I'm using FlexQOS. If I manually set the up/down limit from within spdmerlin CLI I get the message that the speed has been updated (tells me current and past values) but when I go to the qos settings page the values arent...

EDIT: here you go.. think it has to do with the Schedule selector. I had it set to hourly. If I change it back to half hourly this error goes away and the settings save correctly Uncaught TypeError: Cannot read property 'name' of undefined at Toggle_ScheduleFrequency (user1.asp:1469) at...

Only in /opt/share/spdmerlin.d

Very exited to see AutoBW. I'm using FlexQoS. Should your AutoBW implementation be working? If I select the option to manually update the values it says the where updated but if I go to the qOS screen on the router it still has the old values. Also noticed that if I try to change the storage...

I've been using Smart Connect and it's been working perfectly. Only exception was one of the new Vizio Smartcast TVs but I'm pretty sure problem was with the way the TV tries to connect. You run a connection wizard on your mobile device, like the way you connect a Chromecast devices. Apparently...

Try changing the default 192.168.1.x address for the modem. I had the problem with my AC3200. I changed the router's address to 192.168.2.1 since all my network was previously configured on that subnet and it was the fastest way to get the router running but I noticed the list not showing. I...