Recent content by jptech

  • SNBForums Code of Conduct

    SNBForums is a community for everyone, no matter what their level of experience.

    Please be tolerant and patient of others, especially newcomers. We are all here to share and learn!

    The rules are simple: Be patient, be nice, be helpful or be gone!

  1. J

    Support for RP-XXX Access points?

    Will support come for the Asus RP devices which are just APs, Repeaters, Media bridges? I'd like to get one to use the AiMesh feature, but I'd prefer it be a merlin base.
  2. J

    Checking cable modem signal levels through router

    The problem is definitely with Motorola. I already tried an internal lan of 10.0.0.0. It had no effect. But I do have an RT-AC88U as an AP that I will swap with the N66 and we'll see the results.
  3. J

    Checking cable modem signal levels through router

    It's not a cisco modem which is at issue. I could reach the webui for my arris just fine. It's the Motorola MB8600 which isn't letting me through.
  4. J

    Checking cable modem signal levels through router

    My normal subnet is 192.168.0.0/24 I've changed it to .1.0 and .100.0 I'm going to try 10.0.0.0/24 next
  5. J

    Checking cable modem signal levels through router

    what about when I create the subif on the same subnet though? It should work perfectly fine then. I even changed my WAN IP to that subnet. As expected, I lost Internet, but the IP was .100.200. It should then have allowed the connection. Especially wget. But no luck at all. It's definitely...
  6. J

    Checking cable modem signal levels through router

    Yeah, I think the modem is blocking it somehow. I could reach the arris fine.
  7. J

    Checking cable modem signal levels through router

    I have comcast. They weren't blocking it before, and I can still reach it if I plug directly into the modem on port 2. It's definitely the router that doesn't allow the page to be loaded. I'm wondering if it has to do with the public IP. The modem is a bridge. The public IP is assigned to the...
  8. J

    Checking cable modem signal levels through router

    I have an RT-N66U. It's currently running 380.70. I recently bought a Motorola MB8600 cable modem. I cannot seem to load the diagnostic page at 192.168.100.1. My internal network is .0.0 and I can ping the IP fine, but cannot load the web page. If I plug directly into port 2 on the modem and...
Top