Recent content by JustTom

Exploring the log file, I can see it is being progated with this error: process_name_registration_request: unicast name registration request received for name SEC001599362BEA<20> from IP 192.168.1.100 on subnet UNICAST_SUBNET. Error - should be sent to WINS server [2020/05/05 02:00:04, 0]...

Okay there is still an issue hanging around. I'm getting 'no space errors' reported from skynet and diversion. Looking at the directories tmpfs mounted on /var is full with around 220208 kilobytes used. So it appears to be a rogue log file. Filesystem 1K-blocks Used...

Well , I don't want to tempt fate but so far so good after a the nuclear reset. Amtm working fine alongside 2GB swap file. Loaded up Diversion, Skynet and FreshJR QoS. Wifi channels, dns etc set up. Only issue that I run into was a 'no space left on the device' error but a power off at the...

I didn't enable any logging of the firewall, and by that point had done numerous resets so it would have been set at factory default. Currently about 3/4 of the way through a 'nuclear reset'. I'm going to keep it on 384.17 after the nuclear reset and try again so I can let you know of a...

As advised I have left the router alone since I have performed numerous JFFS partion formats and full restores. The new USB arrived today, however as soon as I enabled custom scripts and tried to load amtm I recieved 'can't fork' errors and access to gui ceases. What on earth is going on? The...

Update on stability front - i'm now seeing 50% CPU usage being taken by acsd which I believe is the auto channel selection daemon. JFFS formatted in previous reboot, could that cause issues with acsd? (Kept scripts disabled as suggested by dosborne) I have two other wireless AP in the house...

Thanks, L&LD will do. Your right dosborne - i'll probably just order another usb off amazon and then try this all again when that arrives (leaving custom scripts off in the mean time to check system stability). I have a feeling its probably the USB at this point. This particluar one is a no...

I cannot see any errors in the syslog. I had set logging to errors only, and have now changed to debug. I am now seeing constant dropped incoming packets but I assume that is background noise which my firewall is dropping as expected. I'm currently zeroing the USB drive which was in the...

So the router was pretty stable for 12 hours. The only issue I came aross was when changing USB to 2.0 mode, enabling https authentication and removing wan down redirect. The router required a manual reboot after the settings had been applied to access the web gui. However after 12 hours, when...

Thanks Colin, I performed a WPS reset like you suggested and the router seems stable. I plan on leaving it for at least 12 hours to test the stability After that I will see if I can load up amtm without getting errors.

Firstly - thanks to all who have contributed to Asuswrt-Merlin and custom scripts I was running 384.16 perfectly fine with SkyNet, Diversion, Fresh JR QoS script. Updated today, loosly following L&LD's steps - didn't make config backups, and not all the setting changes suit me - but followed...