Recent content by Lee

Never mind, i searched for the error and found the answer. For the benefit of anyone else, ensure that you DO copy the ----BEGIN PRIVATE KEY--- and -----END PRIVATE KEY------ bits when pasting into the router settings. The guide i linked says not to do this, but clearly it is needed :D

I've re-pasted in the DH, and this time I see different errors in the log: Jul 26 12:55:47 rc_service: httpd 309:notify_rc start_vpnserver1 Jul 26 12:55:47 syslog: VPN_LOG_ERROR: 634: Adding tunnel interface to bridge failed... Jul 26 12:55:47 kernel: br0: port 4(tap21) entering disabled...

I'm trying to setup openvpn for the first time following the guide here for tomato. http://www.howtogeek.com/60774/connect-to-your-home-network-from-anywhere-with-openvpn-and-tomato/ However when trying to start I'm seeing the following errors in the log: Jul 25 15:47:50 openvpn[501]...

ahh, that makes sense! I think cat5 is 100mbit vs cat5e gigabit, which would explain only getting the 10MB/s using the shub. It's the same I had with my old netgear router which only had 100mbit ports, that would only give around 9.6MB/s but as soon as I switched to the Asus with gigabit...

I'm not sure whether this helps, but I have a very similar setup to you (although I've managed to avoid a shub for now) and don't have any issues. PC -> Netgear 8 port switch -> N66u -> VM Modem and I can dl from usenet (astra) @ 12.4MB/s no problem using 20 connections most of the time...