Recent content by Muyfa666

Agreed! ;-)

I think I made several errors in connecting all this. As of today, I pretty much used the switches in default unmanaged mode, and then connecting tthe XT12's to the switches. I forced the XT12's to 2.5G WAN backhaul only, and that made everything work like inteded. Now I have 2.5G to all...

Only the first two switches "work", after that, the wired signal is lost to the other units. Not a cable issue.

Being as I'm not an experienced network person, my thought was that if there were more 2.5G ports on the XT12 units, this would not be a problem at all, therefore I thought a 2.5G switch (unmanaged) would solve it. Clearly I was wrong. The XT12's work well enough without switches, but only in...

I see. And these can't be made to work in my system with the UniFi software either?

Holy reviving of a thread Batman! It's been over a year, but I have not had the time to looking into this anymore until now. I got a couple of Flex Mini 2.5G from UniFi and went ahead to connect them kind of based on post 9 in this thread. I went as the attached picture shows. Internet goes...

I can probably get around this then. What type of switch should I look for? A managed switch?

Will a 100mb device always cripple the speed of the whole nod?

I see. Should I NOT use the Lan3 at all if I want to have the full benefit of 1G?

The lan3 is actually wan. I connect "in" to wan and "out" from lan. Sorry, I'm not a native english speaker.

I'm a bit lost, sorry to say. Will a gigabit switch remedy this? Do I understand correct that I cannot use the 2,5g lan port for anything, because then I will not get backhaul in the right speed?

But port 3 is Wan, and I only have Lan to Wan between the XT12's, nothing else and Cat6 cables. They are all chain connected, so if I disconnect any port 3, all units after that will loose cable connection.

How do I know which of the units it is?

All cables are new Cat6 cables and as far as I can tell, the only cables are connecting modern hardware with faster than 100mbps ports.

Hi. On the topic, I have 5x XT12 connected by Cat6 lan cables. I still get a yellow prompt in the admin console. I use the XT12's as switches so to speak, so I have conmnected WAN port as incoming and Lan1 as outgoing on all units. I don't really see any slowdowns, but any idea why I get a...