Recent content by Neurogenesis

ill try doing this. havnt really done anything at all with SSHing into the router though. Know of any good tutorials though?

I've had this issue prop up since going to 388.2. I am currently on 388.2_2. Long story short I put in the IP for the router into a browser, doesn't matter which one, and the login times out. I have tried multiple devices and issue persists. The only way to get in is to reboot the router. I...

This looks like all of the RT-AC routers, but what about the repeaters, is the RP-AC68U affected?

Topology: I have FTTP with WAN port on the Gateway connected to the box on the side of the house. The AC87 has LAN 3 attached to the LAN 3 port on the Gateway. Background: I initially had the network setup according to the instructions here...

3.0.0.4.382_10513 FW Has anyone had any luck getting the Beacon interval below 20? I'm seeing huge performance gains lowering this from the default 100, then 50, and now to 20, but I cant seem to get it to go below 20. If I go below 20 it reverts to 100.

first off, thank you for showing me that, i didnt know it was over there. now, something weird just happened. i turned off iptraffic, and set NAT Accell to Auto... and i got this: The upload is about half of what it is supposed to be, but the download is MUCH better. Thank you!

No, I havn't. I didn't think it was needed since the Asus stock firmware runs fine with the same cables.

Only two options were Disabled and Auto. If I set to Auto it goes back to disabled. From there checking status there was an message next to disabled "Incompatible with IPtraffic" Which in itself is weird because I don't have any QoS on. (I cant find anything else that looks like it would...

not only that, i was disabling CPU intensive items one by one and rebooting after each one trying to isolate what might be causing it.

Its turned off:

bumpity

So my problem stands with transfer speeds on a gigabit internet connection (att gigapower). On the stock Asus FW I can get ~980 up/down but I am topping out at 297 on the Merlin FW. I have disabled the following in hopes that it would fix it but I cant seem to shake the problem: NAT Loopback...

thank you!

Not sure what to do here, I have tried both the Asus and Merlin firmwares and the client list when on the "Network Map" fails to populate. Thoughts/ideas? Cycled the power on it, and reset the factory defaults, it didn't help.