Recent content by Pizzy09

Hi guys, There's a way to find the access concentrator name of my pppoe session? Any command with pppd? I didn't find it also inside the syslog (only its IP and MAC address).

It is: HW acceleration Enabled (CTF only)

Hi There, I saw that there are many post around there with a similar problem, but I tried all the solutions inside them without success. I have an RT-AC87U since 4 years, always used Merlin firmware (actually I just installed today 384.13_3). Recently, I upgraded my 100Mb/s connection with a...

Hello, on my RT-AC87U after the 384.10 update sometimes the 5GHz WiFi suddenly goes down. It lasts about 1 minute and then it comes back. No errors on syslog. Obviously made hard reset after the update and set manually all the configurations. Any suggestions? No issues with previous versions.

Hi, i have the same problem of the original poster since v384.9 (and also with the newer v384.10, both with factory reset and manual setup). With 384.7_2 was fine. So the only solution is to delete that roule? Has the rule been introduced after 384.7_2?

Same for me. Since the update to 384.9 i can't reach my other LAN devices on my network through OpenVPN server on my RT-AC87U. Also tried to do a factory reset and manual re-set all the settings without success. I can only access to the Asus Gateway and on Internet (set to "Both" on OpenVPN...

Pushed but without success...

Before the beta i was on the latest stable version available: 384.7_2. Anyway, yes i saw the option and it was already in the previous versions. I access to my LAN and to Internet. But i can't reach anymore my modem. Example: My Asus is on 10.0.1.1 My modem is on 10.0.0.1 From VPN since this...

Hi there, I have an Asus RT-AC87U. I've just installed the 384.9 beta 1. With the previous version i was able from my clients connected to Asus's OpenVPN server to reach my ISP modem (connected trough WAN port). Now since the update from my clients I'm able to reach only the Asus network. The...