Recent content by ptocadoa

Hello all, it seems as the installer does not want to start ;)

Effectively @ColinTaylor...I misread I have also uninstalled scribe and right now, dnsmasq.log shows DHCPREQUEST and DHCPACK ! I used scribe to rotate logs. In fact, I will try to install it again and will watch over it. Thanks @ColinTaylor and @SomeWhereOverTheRainBow, as you have shown me...

Next step: uninstall scribe. I will post later my results

Something about the logging has been changed. Although I set do not hide in the UI (upper left), the shell (down) does not show the dns queries that adguard shows (upper right):

@ColinTaylor, when I saw your reply, I went quickly to the option you mentioned..but didn't found it!. So, as I saw installed uiscribe ...I uninstalled it. But unfortunately, although I can see logs under ssh shell, the dnsmasq logs still do not show the info I need.

Hello again, I am sure there are more changes apart from the port because before I installed it, I was able to debug the DHCP leases.

Another simple question, difficult to know if it has been answered before: DHCP debug with Adguard enabled I have been using AdguardHome with my AX58....but I think it redirects my dnsmasq logs to process the dns queries. I am using new devices at home and I want to see the DHCP queries they...

Apparently I have available space at NVRAM: ptocadoa@ax58u:/tmp/home/root# nvram show >/dev/null size: 82448 bytes (48624 left) ptocadoa@ax58u:/tmp/home/root# nvram get vts_rulelist <sshtunel>8080>192.168.1.3>22>TCP><hass>443>192.168.1.4>3044...

Hello all, I wanted to ask you if you have the same problems as me. I am unable to make changes to this tab, port forwarding with version 388.1: unable to correct an entry or deleting+adding it again. Before that, I have been able to correct entries in my ddns tab. Suggestions?

I It is not the asus gui..it's 'home made': a script that sends these measurements (and others) to a influxdb+grafana

Absolutely. Back to 384.19

I'm in version 386.2_4 with ax58u. Anyone with this problem: I cannot see the cpu temp at the GUI. I am getting these messages: May 12 18:02:11 ax58u kernel: thermal thermal_zone0: Failed to get RAIL 0 temperature, ret=256 May 12 18:02:11 ax58u kernel: thermal thermal_zone0: failed to read out...

And what can I do? Replace the USB stick and begin with amtm installation?

Today I had upgraded to this version 386.2_4, but my scripts or even amtm seem to crash.

Hello all I have been measuring my internet connection for many months using a samknows measuring device. In the meantime, I have changed several times my merlin firmware. The measured download speed is as I was expecting: The upload speed is unstable: If I replace my loved merlin...