Recent content by rich710

I also did a factory reset yesterday, but the problem is still there.

Thank you, It looks like this is the problem, is this the same for all Merlin Firmware? or is it possible to update the acme-client through gui or terminal? best regards //Richard

Seems like I don't have double NAT if I do a traceroute.. Tracing route to dns.google [8.8.8.8] over a maximum of 30 hops: 1 <1 ms <1 ms <1 ms router.asus.com [192.168.1.1] 2 1 ms <1 ms 1 ms gw15.A175.priv.bahnhof.se [217.31.164.1] 3 <1 ms 1 ms <1 ms...

Yesterday my certificate expired, The date said 2019/10/6, but it did not autoupdate, I tried to restart my router but It still said 2019/10/6. Then i tried to disable lets encrypt in the gui, and re enable it again, then it got a certificate that says it's expire on 2029/10/7 ?? But if i try to...

So, I'm on a AC87U since some years, if I decide to change it to be able to run the latest Merlin in the future, which Router do you Recommend to get the most bang for the bucks and the most future-safe solution. Even if I know that you can't answer for when Asus decide to not support it...

And if you use the 87U as a AP, I think you should not use the wan-port, just connect your tp-link in one of the four lan-ports

I had the same GUI-issue login problem yesterday when I switched Wifi-channel. and after that I couldn't log in either with Chrome, Firefox or Edge. But when i tried a "private session" in Firefox I could log in immediately.

Thanks! There was a blankspace in a HP Procurve Switch network name, since I changed it, everything seems to be ok in the network--map! :)

Client Status not shown Hello and thanks for a nice firmware! I have an issue with the client status list, after rebbot, it works for some time, but after a day, it is cleared and can't get the clients to show up, even if I push the update-button. Is it just me with My AC87U? I did a factory...