Recent content by Rrrr

What is a browser console? Is it on the Asus or in Chrome?

I upgraded the RTAC56U from 380.x to 384.4. After loading the firmware I simply reset the router by holding the reset button 5 sec. 1. I assume this means a Factory default Restore? 2. Do you recommend to do a Factory default Initialise after a major firmware upgrade? 3. When restoring router...

No luck. Issue with 384.4 fresh install today on the RTAC56U: cannot edit the WAN Unit entry (no more dropbox). Delete works. I reset the RTAC56U to factory after loading the new firmware, with 5 sec press on the reset key. Tried from Chrome and Edge browsers. I hope we will get back the...

Check this out: IP CIDR calculator

:oops: 1) How does that affect speed? I have no additional software running on the router. 2) What causes the router to switch between WANs? Using 192.168.2.1/24 to WAN2 defines all IP's 192.168.2.0 - 192.168.2.255 to use WAN2. Why not the router? 3) Will the router not switch between WANs if...

You're the man! Thanks for the taking the effort to write this tip. It solves all problems: we can now use Dual WAN and bypass the load balancing (which causes all kinds of outages), without having to manually assign a WAN route to each device. Question: In order to get the benefit of all IP...

How nice of you, appreciated! But no thanks. I take more out of these forums than I can give :)

Nice idea, although a GUI solution would solve issues with load balancing experienced by many. Without wanting to go off topic: about the VPN routing script you found I have a question for you I will ask you in a new thread :)

@MrJackBlack wrote here: 1. can it route certain IP clients through VPN and other clients regular through WAN1 as well? 2. which thread deals with this script? Thanks

Instead of using 0.0.0.0, try leaving the destination field empty ;)

Thanks for the info. I hope Merlin is reading this. It would be great if he sees a way to enable a range. On the second issue with source IP : all: I don't understand why it solves lag and other issues, but if true, it may be a solution that can be applied by Merlin (apologies to Merlin for...

Can you try the first rule like 192.168.1.0? Why do you have rule 3 and 4?

Thanks. I was wondering if you can set a default, something like this: Source IP: 192.168.0.0 Destination IP: (empty) [ means all IP destinations ] WAN Unit: Primary WAN That would mean every new device on the LAN would go through the primary connection. No load balancing. Can this be done?

0.0.0.0 does not work (anymore), if you leave the field empty, it will show 'all'

Nice, how does QoS work for you now?