Recent content by safwan264

the config file does not has these entries. I manually copy pasted them using nano into config.primary.sh in /jffs/configs/cake-autorate. If i remove them the system will revert to default?

yes i thought so as well. This is pattern among my ISP. First test run slow speed, next test run good speed. The "ms" settings in config file are posted by you on git. These are for latency or for improved bandwidth?

hi, i have been testing now, again, my current values are: dl_avg_owd_delta_max_adjust_up_thr_ms=30.0 # (milliseconds) ul_avg_owd_delta_max_adjust_up_thr_ms=30.0 # (milliseconds) dl_owd_delta_delay_thr_ms=80.0 # (milliseconds) ul_owd_delta_delay_thr_ms=80.0 # (milliseconds)...

i have been testing cloufdfare detailed speedtesting: 1. behind the asus QOS, i score bad on gaming and poor on video. 2. direct with RM-551, i score bad on everything. 3. with my balong 5000, i score bad. maybe i would just keep two sims, one for home and as LTE for maximum speed and other...

so far i am just testing, because i was before on H155-381, balong 5000 based CPE, and problem was ping acceptable but in between were major lags which almost made it unplayable. With my new setup, suncomm 08 ultra, RM551 based CPE , things look better, the above screens are from new CPE which...

ok , following your advise here is what i did and its result: 1. disabled TTL = no change, kept it disabled. 2. played with MTU, with LTE only mode the ping -f -l 1472 8.8.8.8 worked fine, but beyond this "fragment error". 3. with 5G NSA, the MTU changed itself! and then 1464 was new max...

Is there any other solution except to use two sims. One for all purpose unlimited and other like 10gb per month only for gaming?

by both speedtest and fast, on the client, while on ASUS, they have builtin speedtest, the test on client is with wifi, which is coming from AP, AP is connected to asus. the wifi is 2.4 and speeds connected are more than 100/100 (i am very near to the AP).

it is set to 1500 as default, i have changed TTL to 65, i have selected only LTE, because 5G NSA makes both speed and latency poor.

do you mean that the managed port i connect to tplink c80 as AP, and limit the port speed to like 25 mbps, any device connected to the AP will bypass that limit?

Pitfall: I was wrongly checking the fast.com from connecting to wifi after router, i checked the speed from the QOS panel itself, and it was more then 80 mbps, which means that router is receiving full speed from CPE but after QOS algorithms, it is giving reduced speed to devices connecting to...

hi, i have 5G/LTE connection. My router has quectel RM551, its made by sumcomm. From this router i connect to ASUS RT-AX58U, the only purpose is to limit the speed of wifi for all house , as shown in settings picture of QOS. I have wifi on AP which is tp-link connected after ASUS. While i also...

hi, i have asus router and i want to do qos, total limit, i have about 30 mbps and i want to limit it to 20 mbps towards my access point so that 10 mbps is always avaiable for my gaming setup and also this will keep the latency good. But i hear that qos on asus router or any router will disable...

hi, i have 5G/LTE connection, it is slow, barely get 20 mbps and 15 mbps D/U during peak and this is when i want to game as well.......... i have used cake-autorate, cake, asus adaptive, but in theory it does not work and in reality as well does not work except cake-autorate. However...

hi, lynx, old post, but i experimented, i am copy pasting, i hope it helps, i have cpe 155-381 and only set to 4gLTE and 5G gives very poor speed on the CPE, i have it bridged to asus ax58u and using default merlin cake (for now). Microsoft Windows [Version 10.0.26100.3775] (c) Microsoft...