Recent content by saizzz

@superclyde911 3.0.0.4.388.23013 can be found here https://www.asus.com/ca-en/supportonly/zenwifi%20pro%20et12/helpdesk_bios/. Hope you get it sorted!

Downgraded from Beta 9.0.0.6.102.4856 to this released version a few days ago and everything seems to be working fine. Three node mesh with wired backhaul.

Has anyone tried to downgrade/re-flash from the latest beta to this release version?

No major issues to report with the beta. I've had the 5ghz network slowdown on two occasions - solved with a reboot.

@rsnhakan so far, no issues with nodes disconnecting using this beta. I'll post a longer term update next week or sooner if I encounter issues.

Took one for the team and upgraded. I was setup for dual WAN failover with fallback disabled. For some reason it would not use the primary WAN and always restarted with the backup active. I enabled failover and all seems to be working so far. Setup: Router mode, three node mesh, wired backhaul...

I haven't tried it yet. Given the last firmware caused problems with wireless backhaul, I might wait to hear how others are doing.

Link Be noted: This is an early stage beta, there might be bugs. This version can be downgraded via web GUI only. 1. Recap new features of 3.0.0.6.102: Guest network Pro(SDN), VLAN, Auto USB WAN backup, iPhone tethering, Multi-services WAN. 2. Re-defined VLAN, supports Trunk, Access mode with...

I have a three node mesh with wired backhaul and WAN failover that was working fine until this morning. I woke up to disconnected nodes and I've attempted to hard reset but the admin page won't load (even tried wired connection). Oddly, setup completes from my iPhone but then get "Unable to use...