Recent content by senel

UPDATE: I got it working. Today, I!ve noticed that 3.0.0.4.384_81049 was released for 86U. Now it works fine :) EDIT: fine = I put it on same spot where old repeater was. My internet speed is 100Mb up/down; 1:1 aggregation. Measured speeds through the original repeapter where 93-95 down, 97-99...

I tried to downgrade the 56U to 3.0.0.4.384.45708 + factory and NVRAM reset and the problem is still same. I can see it in 86U UI as available mesh node but the pairing still fails. I don't want to really mess with 86U and still hoping some other way exists.

Hi, went through steps from post 8 and it seemed fine so far. I can se the node on my 86U (both upgraded to the latest available stock firmware) however when I try to add the node, it fails at the end on unable to add bla bla... Any tips? I checked some of them of forum like connect 86U LAN to...

Seems so. In professional settings, radio is enabled. Thanks for the cooperation, anyway,

I tried to switch back to Asus standard FW together with factory reset + electrical reset with zero clients connected but the result is still same. For the manual channel selection, I can`t select any channel:

Hi, it seems that 2,4GHz radio just died - LED is off and I can`t sarch for that network. Also, Wireless -> WPS show no MAC. I tried the resetting device to factory + hard reset but nothing helped. If anyone could give me some advice to try before sending router to RMA, it would be really...

RT-AC56u upgrade from x.53 causing WIFI not functioning properly - slow, frequent drop out, can "serve" only one connected device at time, others are disconnected. Tried factory setting with same results. Downgraded back to x.53 and everything works fine again.