Recent content by shobhit_bhardwaj

I am running same merlin on the nodes as well. I have this running with same for almost 3 years now and only recently I started seeing this problem.

Hi folks, I am running a mesh with 2 XT8s and one RT-AX86U. One of the XT8 is primary and other 2 are nodes located at different floors. For sometime I am noticing that the client list in AI mesh is not showing anything. I do have clients conencted and then show up fine at the home screen...

I have a technical question on PPPoE here since most of you are using Bell. I am setting up my AX86U is PPPoE with bell fibe, my router is getting the public IP and is able to ping or nslookup out to the internet. Problem is from the lan network. Anything from my local lan is unable to reach out...

I lose connectivity to 192.168.1.0/24 or any outbound connection once I disable NAT. Trying to troubleshoot what exactly is going wrong with that.

Hi, I am running a mesh with 2 Asus Zen XT8 and 1Asus RT-AX86U. 1st XT8 is primary, 2nd XT8 and 86U are nodes. Here is my current network setup: ISP modem (in bridge) -> Sonicwall Firewall -> Asus XT8 primary - Clients Sonicwall LAN interface (X0) - 192.168.1.1 Asus WAN - 192.168.1.2 Asus...

I meant that I have used 160 MHz on RT-AX86u and Asus also confirmed that it have the option. I am not anywhere near airport or weather radars. Also they confirmed that chipset supports it, it's just locked in the firmware which they can't do. My point is that if the hardware supports it, then...

I bought the pack of 2 XT8 15 days back and have the same issue of 160 MHz not being available in the settings. I do have a RT-AX86u and I know that 160 MHz works in Canada. But the question is, should I keep the routers or return it just because of 160 MHz not being available? The mesh is...

What do you suggest is the most optimized way to get this? I am also looking to fetch router's resource usage & temp (cpu and ram) and also current b/w flowing through it. If possible current b/w per client.

I want to capture the geoip of the connected IPs and send it over to grafana. doing it from syslog is too much of a pain. so was wondering if getting dump IPtable will help.

I am using RPi3 as syslog server and sending syslog from my AX-86u to it. I am wondering if there is a way to send iptables from the router to RPi3? I am running latest Merlin on the router.