Recent content by stewie3128

Hello SNB - tomorrow, I’m replacing my RT-AC3200 with a Ubiquiti EdgeRouter 6P and UAP-AC-PRO access point, and need advice on setup/config. Here’s what I’ve been working with: -Single story house, 3,000 sq ft, lathe and plaster construction -ISP: AT&T Fiber symmetrical gigabit -ONT feeds an...

Obviously that particular test is an extreme example, as the speeds I'm getting from the ATT modem's onboard speed test are only showing 970 each way, but I just wanted to show what can happen if you follow the M&M steps. Bufferbloat is now A or A+ on dslreports, which is also consistently...

Check out my similar thread from just a day prior to yours - I’m also on ATT gigapower, and have an inferior router to yours (RT-AC3200). After following L&LD’s M&M guide when installing 10_2, I’ve been getting even better speeds than I had pre-firmware update...

Here's my latest speed test.... for reference, I'm paying for symmetrical gigabit from ATT fiber. Thanks again for the M&M guide!

Thanks much L&LD, I followed your guide and it's back up to where I expect it to be on all the different speed tests, and even got an A+ in Bufferbloat from dslreports! First time on ATT. I don't know if there was any secret junk in JFFS or what, but it worked. Thanks again!

Turned it off as part of the troubleshooting, no apparent effect on either CPU or throughput. It’s currently off.

Today upgraded from 380.68 to current 384.10_2 on my RT-AC3200. Reset all settings after flash, recreated them from screenshots, and I'm getting at-best 450mbit on my gigabit fiber connection. Earlier today I was averaging 890-910 from Fast.com, and high 700s from dslreports. My ATT modem...