Recent content by SubNoize

congrats and thanks for sharing. Can this do the following? Isolate guest 1 2.4 and 5ghz from the main network whilst sharing access between the 2.4 & 5ghz guest network? Say for example a share house. Room mate 1 has access to the main network, room mate 2 has access to guest 1 2.4 and 5ghz...

did it ever get resolved? same thing happened to my nodes overnight

Does this exist? It's a relatively niche thing but a page that displays the latest connected devices and adds to it until it's checked/cleaned would be helpful especially for tagging them/assigning them. I know guest networks exist but I could be at work, my wife has a friend over and gives out...

so there's currently no way to get the aimesh node to assign 192.168.2.xxx to the connected devices? asus are being so lazy

If when I created the AImesh Node I had your test/dev version of YazFI on the main router, does that config then get copied to the node at creation? I've since updated to the latest version and when I connect my device to the network I show up in SSH as a connected device under (192.168.2.xxx)...

My GN1 clients aren't being assigned their own subnet. When I check the IP's they're given they all have 192.168.1.xxx when YazFi should be chucking them on 192.168.2.x and 192.168.5.x The Guest network predates the YazFi installation, does it need to be created after Yaz is installed?

what do you suggest for those of us who have used your develop branch?

So I've installed the latest devlop but it doesn't seem to be working. Also I think this answers my question right. https://www.snbforums.com/threads/yazfi-possible-to-merge-2-4ghz-and-5ghz-as-a-single-subnet.69368/ @Jack Yaz I'm on the latest devlop branch 4.1.5 and when I click enabled "yes"...

did this work for you?

Thanks, @L&LD :) and thank you for your Nuke guide, my AC86U seems to be stable so far. Yes, so I have it working at the moment like this. Which is also fine, I don't mind that the guest network is also being broadcast from the main router node. So this is how I have the GN1 setup and the...

Hi, Please excuse my crude illustration. I'm looking for an answer for what is potentially a simple issue. As you can see I have the main router which broadcasts 2.4 and 5ghz (red). I would like this to be extended to the blue node at the other end of the house so everything is on the same...

Hi, Hopefully this is in the right place. I'll start by saying sorry for my complete noobness but after a few hours of googling around I haven't been able to get anything working so I figured since my router is ASUS RT-AC66U running Merlin firmware this will probably be the best place to ask...