Recent content by Sven Eric

Hi, I'm trying something similar because my parental controls toggle keeps switching back to OFF for some reason. to find out which nvram setting i needed to tweak, I did an "nvram show" when time scheduling was enabled and when it was disabled. I captured both to separate files and then did a...

Again, thanks for your suggestions and help, but that was a whole lotta work, for a whole lotta nothing. :) I took the steps mentioned above, and then put back all my settings by hand (I'm not using the standard .50.1 address, so that's a bit of a bother). Anyway, I setup the parental controls...

That sounds like a plan. Do I factory reset from Merlin or do a “30 second press every button-hardware”-one?

Thanks, because I have the issue with the original firmware I think it’s an issue with the device itself. I know you can ssh into the device. Is this a switch you van set through the commandline? Because then I would just run that every hour or so using a cronjob.

I appreciate the suggestion but the password is strong (generated by keepass) I don’t even know it. Only browser to have stored the password is my pc which requires 2FA to unlock. I experienced similar behavior with the ASUS original firmware and was hoping Merlin would fix it.

Hi All, i have an ASUS RT-AX88U with 384.17_0 loaded. The toggle for setting (any) parental control keeps switching back to off after a few hours. The same goes for individual devices that I have blocked. After a few hours, they get re-enabled again. The router is not rebooting or anything...