Recent content by sWORDs

@upinsmoke I get that settings have been updated sometimes too. Rebooting the router solves it for me. I also don't always get the pages, refresh in the browser works. It doesn't happen a lot, but I'm seeing that issue too (not using ta version).

I've tried 1000,800 but it does not make a difference on the cpu load. It still goes to 100% when doing a speedtest with 500/500.

It being inside the firmware doesn't mean it's slowing it down when turned off. Even turned on it's not costing that much, with everything turned on @AC68U it's using 72-74MB of the 250MB RAM available. And it's still routing 500/500 with PPPoE. There are others reaching 740/631 without PPPoE...

Then an option is to trunk iptv to a managed switch. I've never seen a device with more then one utp as output that isn't a router. Maybe it is a router but in bridge. Are you sure the Asus does not get an internal ip? Could you give the first section of the WAN ip on the Asus? If it's truly a...

The parental controls and AIProtection are also available on the AC68U with RMerlin's firmware. So with that reasoning you might just as well buy an AC68U as long as you don't want to mount it to a wall.

@CiscoX I think I'm going to order the AC87U and check what FA does on CPU usage compared to level 1 CTF and of course to see the benefits of the extra 200 MHz. I've just asked a company to 3D print some wall mounts for my AC68U, so I can use that as an AP at the attic, replacing my 'old'...

@CiscoX Makes me wonder what you would get with Adaptive QoS with the 200MHz extra of the AC87U. Do you also use PPPoE? I wasn't worried, I was quite impressed as most routers drop to roughly 90Mbit when enabling QoS (Because there it disables CTF). And about that donation, good idea, I think I...

@RMerlin I don't know what the appropriate place for a feature request is, but could you extend the IPTV manual settings in the webGUI so it's possible to also set port 2 besides port 3 and 4? What would be even greater would be a VLAN page with trunking options, but that would be a lot more...

For some IPTV setups you need to assign the port to a VLAN, also you might want to enable IGMP snooping.

There are many solutions to your problem. It al depends of the options of your equipment and wishes. You could remove the Asus router (or just use it as an AP) and connect the switch to the router of the ISP. You could place the Asus router as first device after the NTU and trunk the IPTV VLAN...

IPTV manual settings extension for port 2 Moved to latest topic.

I'm having an issue with 376.44 not seen with previous versions. When I use VPN I can only connect from client to router, nothing else on the network is reachable. I'm having this issue with a brand new AC68U router (upgraded to 376.44 rmerlin before doing any settings), so not upgraded from...