Recent content by tglesel

I have just updated. I noticed that my Mesh connection-point router stayed on 609 firmware, so only my main node got 668 after I did an auto update. I manually had to update my mesh connection-point router to 668. Has anyone else experienced this?

Thanks for the hint 👍 Changing 2.4GHz band to -60dBm did the trick!

I have a well working Mesh network with two XT9s. The only thing that puzzles me is the only two 2,4 GHz Wi-Fi devices I have, always connects to the same mesh router also if there is another mesh router near by with a much stronger signal. I do no see this issue on any of my 5 GHz devices, they...

Glad I could help :)

This issue is now fixed in 388_23630!

I have noticed after upgrade that the RX92 starts to constantly access my USB attached HDD so it never goes into hibernation. I have tried to disable various usb-drive services, but the disk activity continues. Has anyone noticed this as well? I have downgraded firmware and the constant disk...

Thanks, I will try to look into that variable, and see if I can get it to work. .smartsync is a directory so I need the -r

Sounds like a good suggestion. My Linux knowledge is however a bit fragmented. Would you be able to give me a hint on where I find service-start and how I add the command to the file Would it be possible with "nvram" command? As far as I can see it is supported in stock Asus firmware, but not...

I am using stock Asus firmware on my 92U, so I do not think I can use "cru"

I need to run a simple command during startup of my RT-AX92U = "rm -rf /tmp/mnt/mydisk/.smartsync" to ensure smartsync of my usb device is working after reboot I am absolutely not a Linux and shell script expert, but I am familiar with some basic Linux commands, and I have setup telnet access to...

Yet another firmware upgrade: 3.0.0.4.386.44985: 1. Fix AiMesh issues 2. Improve system stability 3. Fix WAN DNS setting cannot setup LAN side pihole server. 4. Fixed DoS vulnerability from spoofed sae authentication frame. One more “Improve system stabilitet”?? like previous upgrade. Has...

I have not experienced wan issues on either 43084 or 41712. I have however experienced consistent Wi-Fi stability issues on 41712 (see my previous post in this thread) so I am quite pleased with 43084, it has been running rock solid now for 27days after firmware upgrade.

Try (as a test) to disable the 2,4ghz wifi to see if the fatal error messages disappears. It worked for me, and I do not need 2,4ghz Wi-Fi and the fatal errors in the log disappears. If I enable 2,4ghz again the messages reappears.

I upgraded 2 days ago (without factory reset) and everything is working well. However I want to see this firmware run steady for more than 14-18 days. My experience with the previous firmware was that Wi-Fi consistently stopped working/responding after 14-18days, without any signs or error...

Mine are mostly working well, so I think I will wait a bit to see what is being report about the new fw.