Recent content by tts

Just do a google search, reddit, amazon product review, and netgear forum, complains are everywhere. Basically, rax120v2 reboot itself several times a day for no reason. There are many theory on this, cpu overload, heat design flaws, manufacturer flaws, official forum even suggest put a laptop...

Netgear has at last rolled out a solution to address the long-standing reboot problem that has plagued RAX120 users for over a year and a half.

Thank you guys! But I still confused on why they use same channel, this sounds a bad design to me since same channle could make signal worse.. one ac68u in "Access Point(AP) mode / AiMesh Router in AP mode" and another on in "AiMesh Node", both connected to the same router by wire.

I convert two ac68u AP Mode to the AiMesh(Ethernet Backhaul Mode), it's really a pain since i have to hard reset one ac68u to get work, but it's good in the end. One thing i noticed is that, both ac68u now using exact same channel for both 2.4 and 5. I thought this is a very bad practice...

after upgrade to this version, i am unable to access Web UI anymore. How to fix it? SSH still working. EDIT: Looks like manually run `service restart_httpd` should be able to get Web UI up and running, but it can't start it on its own after reboot. tried many times.

I tried this on my ac68u, and it really boost my performance, but it roll back to 800,666 by itself at a later time. How change the clkfreq permanently?

Another reason for me to stay with 385_20633 for now.

Still 91MB firmware. Not fixed?

The only think i care about is stability. 386 series always like beta to me. (for ac68u)

I use AC68U as AP only, if there is no WiFi performance improvement, should I upgrade? Thanks,

Is 386 stable enough to upgrade from 385? I heart a lot of bad story on the 386.

Actually, for my test run, the result on the multiple runs for the same router is about the same. Since I did it during midnight(less interfere), with only one client connected, exact same location.

I don't think so, because the cpu usage is around 60-80% under traffic. and then dropped to zero when traffic is gone.

I have two AC68U, one is converted TM-AC1900 with 800M CPU, the other one is V2 with 1.4G CPU, all same factory firmware. I put both router in AP mode, and noticed that there is not much difference in the wifi performance, the V2 is even slower in upload speed by ~100Mbps. Has anyone else...

I got a AC68U V2 today, detail as following: FCC ID:MSQ-RTAC68UV2 CPU: 1.4 MEMORY: 256 FLASH: 128 CFE: 2.0.0.6 Hardware: 2.2