Recent content by UrbanRogue

I get that under 100MBS is thinking Fast Ehternet etc. but if im getting under 100 directly wired to the Main ET12 with a Cat6e cable Im a little confused how its only getting that speed. As well im not concerned what I spent on what, etc.. Im more concerned with the issue at hand. my old...

updated firmware and can see color code now. both show green Green from Bell to ET12 and green from 2.5G to switch

This is what my Status page shows doesnt really have a color code thing going on Problem with Bell and there implentation is they dont allow the HomeHub4000 to have a bridge mode. best I can do is set up an Advanced DMZ to get the ET12 to receive its own WAN IP from Bell.

all cables are Cat6e cables and when I was on Rogers Cable internet everywhere was getting the 500MB down. so Im doubting its a cable issue If I test speed via Bell Modem I get the 500+ up and down.. ya I realize 6000 sqft is advertised . just assuming that having 3 AiMesh devices (1 on each...

So I switched to Bell and recieved the HomeHub4000 modem. which did not get WIFI all over the house. I opted to get a set of Asus ZenWifi ET12 and an additional RT-AX88U for an AIMesh Node. I have the wifi shut down on the Bell HH4000 and have the ET12 set up as PPPOE. If I do a speed test...