Recent content by vii

i'm still using 384.17, which is what I had when I started this post. Still having slow uploads as well. I've just accepted the 160-200Mbit limit my iOS devices were seeing. I still have to update to 384.19, but since I usually do a factory reset after upgrading firmware I needed to backup all...

sure thing, i've attached both settings

so it seems the iphones, ipads, and other wifi adapters in the home don't have 160mhz. I forgot my motherboard had integrated wifi, and I disabled my ethernet and connected using the Intel AC 9560. This is with whatever outdated drivers windows auto installed, and without the external antenna...

System's are stable, no fluctuations in speeds, no drops, no disconnections, no compromised bandwidth from the numbers I've post since I set it up. It's just I immediately noticed that upload speed was halved, and that's it. Been rock solid 600-650/200 for every wireless device, unless I'm...

Very helpful information, thank you L&LD. What I meant about the 40Mhz was in regards to the option you mentioned I set for my 5Ghz, manually setting 160MHz. The 2.4GHz network (since I broadcast 2 separate SSID) has the options as well. It looks like the 3 options I can set for the 2.4 are...

Here's a quick channel survey after scanning a couple of minutes. Looks like 11 would be best 2.4ghz channel, and I supposed I could try 36 and 40. I was on 40 at the time of this test, so those 2 are very low usage for 5ghz. I live in an apartment building in New York City, but for purposes of...

@L&LD hi, thanks for reaching out. would manually setting a channel bandwidth of 160mhz prevent devices incapable of that band to connect to the 5ghz? Also the 'capable' for protected management frames is tied to wi-fi agile multiband option being enabled. is it okay to disable this as well?

Looks like the router auto selected channel 40/ 160mhz iPhone speed tested at 620/212 Mbps 1200/1200 link speed with router at 80Mhz connected using ax Would turning off auto-and manually selecting 40 give a different result, or should this serve the purpose of the test since it had it auto...

Channel spectrum is something I admit I know little about. Save knowing not to use a saturated channel. I can scan my location again using a site survey app and find a channel that isn't in use, however should I land a fixed channel on a DFS channel? Or use the something in the UNII-1/2 area of...

thank you FTC, looks like Merlin disables "Airtime Fairness" by default and I confirmed it off. I turned off universal beamforming though, though the speed tests remain the same.

Yeah, made sure QoS was off. Haven't added those settings and factory defaults don't include them on at all either. But I did triple check that. You're not using merlin on your main router I noticed? AsusWRT? Maybe I can try that, but i'm sure someone using AX88U and the same merlin build isn't...

wifi 6 disabled/ 160mhz disabled/ auto select channels inc DFS disabled speed test: 551/209 Mbps - (ac) 2 streams, 80mhz -47dBm rx/tx 866/866 Mpbs wifi 6 enabled/ 160mhz disabled/ auto select channels inc DFS disabled speed test: 678/219 Mbps - (ax) 2 streams, 80mhz, -51 dBm rx/tx 1200/1200...

Hi everyone, first post. I just picked up this router and flashed it with merlins wrt 384.17. I reset the router afterwards to factory settings and checked the initialize box to get the cleanest wipe, and set it up. Problem i'm having is i'm seeing less than 1/2 of my upstream bandwidth during...