Recent content by Yadda

Hi, We have a small office that hosts 3rd party often that need Internet access. I would like to have a wireless firewall that for GUEST access only allows traffic to Internet (HTTP, HTTPS, FTP, etc). So there would Guest login, then company users who would login with their credentials for...

The MoCA adapter is a Layer 2 device so no TCP/IP involved. Cable like the diagram in the install manual and you will be fine. If you have done that, reply back with how you cabled it for more troubleshooting. I have installed these for 2 friends and all work OK. Install: Main Moca...

If you have any pull, contact Netgear and tell them many need 3 adapters not 4.

where can I buy a single MCA1001?

I was looking to buy one more MCA1001 and came across the MCAB1001. Anyone know what the difference between the two models are?

Turns out TWC changed the way I had cabled my living room equipment when they installed a SDV adapter. I fixed that and now all is good!

I direct connected the MCA1001s with a run of coax that came with the kit and they worked fine as a bridge. So I it looks like my home coax is the issue but am not a coax tech so am lost at this point. I was wrong about my splitter; it is a 3-way branded TWC with no ports uncapped, all used...

More: If I turn off the MCA1001 connected to the MOXI DVR (the other MCA1001 is connected to cable modem), the TV picture in HD is OK. If I power on the MCA1001, the TV picture freezes occasionally. This happens both when channel is set to SCAN and the highest band. The MCA1001's are...

I got confused because the Installation Guide calls the MCA1001 an Ethernet Adapter, not a Bridge, and then talks about configuring it with a IP Address. So, sir, you are correct. I think the directions need to be more clear on this point. Thx, Dan

Deleted my original post. Just realized the MCA1001 is a bridge and uses no ip address when in bridge mode.

Hi I just tried to install a Netgear MCA1001 Kit (2 adapters). My network is 192.168.100.0/255.255.255.0 gateway 129.168.100.10. First off, the kit came with one adapter being on current firmware and the other being one level behind. I update the one to current firmware then attached them...

Split a Kit? I need a 3rd one too! I would split a buy with you. PM me and reply to this post if still interested.