asus xt12

Hey, My current set up is 2x XT12 and 2x XT9 running in AiMesh. Main router is XT12. XT12's run latest @RMerlin firmware, the XT9's on the lates stock firmware as unfortunately no Merlin support. Everything has been rock solid and works well. My network has been expanding to the point at which...

Erstwhile lurker in these forums and have picked up much advice recently, thanks to all your contributions! I have a super frustrating problem I hope you can advise on, 'cos I've had absolutely no traction with Asus customer support. Current Mesh setup with wireless backhaul (old but works...

zEN pro xt12 failed during firmware upgrade. I tried the firmware restoration utility : https://www.asus.com/support/FAQ/1030652/ I changed the ip address in TPC TCP/IP V4 to 192.168.1.100 and other ip s such 192.168.1.1, 192.168.50.1 with subnet to 255.255.255.0 and used the upgrade utility...

ANy help appreciated. When i tick 'Disable 11b'in Wireless Mode, InSSIDer shows that i have a config mismatch and indicates that one node is broadcasting on b/g/n/ac/ax and the other is g/n/ac/ax?

Switching from stock to Merlin 386.7. ASUS XT12: Where did "Bonding/ Link aggregation"-setting go? (In stock firmware under: LAN -> Switch Control)

I have my AX11000 set up as the main router and 2 x XT12 connected to it as nodes, + XT8 on another floor. After my printer - one of the few 2.4 devices - would not connect to any of the nodes but rather to the main router only, I checked the available wireless networks and can see that neither...