serial

I've been trying to configure my newly bought Asus RT-AX88U AP using nvram commands via serial connection. Like, when I try to set the below values on the AP using nvram commands, the nvram values are getting set (verified by using 'nvram get' command). But when I try to do 'nvram restart' OR...

So, my Asus RT-AC88U was acting up after internet outages so I thought maybe a firmware upgrade was advised, it failed. I tried putting it in rescue mode but it never worked, and I tried erasing the NVRAM via the WPS button which also didn't do anything. I learned I could hook up my RPi to...

I recently did an RMerlin upgrade and botched it. I can`t say for sure how but likely not resetting the router properly and unplugging the unit at a critical point. Tried the firmware recovery, setting IP on computer and holding reset. Twice, recovery loaded to about 80% then pooched. After...

Hi, I am trying to recover a router I purchased from eBay. It's Belkin F9K1124 AC1900. I tried to recover with UART but this is not recognising any commands. I pressed esc while booting and this is what I booted up to. It's not CFE as other websites mention. Resetting with TFTP by pressing reset...

Hi all, Just got a new TM-AC1900 a few days ago and new to all of this. I have been stuck with this problem for a few days now. Problem: I was in the process of flashing my TM-AC1900 to Asus RT-AC68U firmware when it stopped. When I next powered it up, there were solid lights on WAN and all...

Hey guys, I would like to install a kernel module on the stock firmware of the Netgear R9000. Are there serial pins like for the R8000? --> https://www.myopenrouter.com/article/how-set-serial-console-netgear-r8000 So that we then can connect with ttl-usb cable, interrupt the boot process and...