AP Only mode vs Wireless Router Mode

[bheiser1]

I believe based on the functionality activated in 3.0.0.4.260.21 on my RT-AC66U I have the device in Wireless Router Mode. In fact when I go to Administration->Operation Mode, that's the selection that's ticked.

However when I view System Log -> Wireless Log, I see this:

Mode : AP Only

Not sure if that last message is just displayed in error or if something else is going on...

Probably not a big deal but just thought I'd point it out .

 

[RMerlin]

I believe based on the functionality activated in 3.0.0.4.260.21 on my RT-AC66U I have the device in Wireless Router Mode. In fact when I go to Administration->Operation Mode, that's the selection that's ticked.

However when I view System Log -> Wireless Log, I see this:

Mode : AP Only

Not sure if that last message is just displayed in error or if something else is going on...

Probably not a big deal but just thought I'd point it out .

I believe that means that from the radio's point of view (not the router itself), the radio acts as an AP, to which clients can connect.

That output is actually generated by the wireless driver (except for the link info, which I am appending through the firmware itself).