kleinerflo
New Around Here
Hello everyone,
I’m having an issue with my ASUS AXE-11000 router.
Since performing a factory reset, WiFi is no longer working.
Current state:
The following appears in the kernel log:
Jan 1 00:14:42 kernel: ubi2: attached mtd10 (name "misc1", size 8 MiB)
Jan 1 00:14:42 kernel: ubi2: PEB size: 131072 bytes (128 KiB), LEB size: 126976 bytes
Jan 1 00:14:42 kernel: ubi2: good PEBs: 64, bad PEBs: 0, corrupted PEBs: 0
Jan 1 00:14:43 kernel: UBIFS (ubi2:0): mounted UBI device 2, volume 0, name "nvram"
Jan 1 00:14:44 kernel: UBIFS (ubi2:0): un-mount UBI device 2
Jan 1 00:14:44 kernel: ubi2: detaching mtd10
Jan 1 00:14:44 kernel: ubi2: mtd10 is detached
Additional information:
I still have an old configuration backup.
If I restore it, I can no longer log in afterwards.
Does anyone have suggestions on how to proceed from here?
Is there a way to reinitialize or check the mtd10 / nvram volume?
Any help would be appreciated.
I’m having an issue with my ASUS AXE-11000 router.
Since performing a factory reset, WiFi is no longer working.
Current state:
- LAN works
- Web interface is accessible
- No WiFi networks are broadcast
- Boot process takes significantly longer than before
- After a reset, it can take up to 20 minutes until the router becomes reachable
- Installed multiple different firmware versions
- Reinstalled firmware using Rescue Mode
- Performed several factory resets
Relevant log excerpt
The following appears in the kernel log:
Jan 1 00:14:42 kernel: ubi2: attached mtd10 (name "misc1", size 8 MiB)
Jan 1 00:14:42 kernel: ubi2: PEB size: 131072 bytes (128 KiB), LEB size: 126976 bytes
Jan 1 00:14:42 kernel: ubi2: good PEBs: 64, bad PEBs: 0, corrupted PEBs: 0
Jan 1 00:14:43 kernel: UBIFS (ubi2:0): mounted UBI device 2, volume 0, name "nvram"
Jan 1 00:14:44 kernel: UBIFS (ubi2:0): un-mount UBI device 2
Jan 1 00:14:44 kernel: ubi2: detaching mtd10
Jan 1 00:14:44 kernel: ubi2: mtd10 is detached
Additional information:
I still have an old configuration backup.
If I restore it, I can no longer log in afterwards.
Does anyone have suggestions on how to proceed from here?
Is there a way to reinitialize or check the mtd10 / nvram volume?
Any help would be appreciated.