[Issue] OpenVPN server Allowed Clients section missing after ON/OFF via GUI

[sanchez13]

Hi,

I have configured OpenVPN server on my RT-AC88U (latest Merlin fw 384.13). I identified one problem. My OpenVPN server is used for site to site connection.

- Manage Client-Specific Options - Yes
- Allow Client <-> Client - Yes
- Allow only specified clients - Yes

All working fine. After router reboot or power OFF and ON, all settings are preserved, but if OpenVPN server is disabled via GUI and then is enabled again via GUI, Allowed Clients are gone :-(

I must again specify settings for my clients (common name, subnet, mask,...) and then all forking fine as before...

S.

 

[sanchez13]

Settings from this section missing after ON/OFF via GUI:

@RMerlin: same problem was observed on older version of Your firmware. Can You fix it ?

thanks

S.

 

[octopus]

Have you hit apply after applyed settings?

 

[sanchez13]

Have you hit apply after applyed settings?

Yes, without apply this settings not working
These settings preserve if I reboot whole router, or turn the router power OFF and ON.
Only if OpenVPN server is disabled and reenabled via GUI, then this setting are gone...

 

[RMerlin]

Thanks, fixed.